Desk Mount Compatible with Logitech X56, X55,X52,X52 PRO，Thrustmaster Sol-R2 HOSAS, farmstick, T - Flight Hotas One, T - Flight Hotas 4, T - Flight Hotas X, T.flight Stick X (2 Pack)

I have had it for more than two months and I am more than satisfied. The mounting to the table is strong and at the same time easy to remove in case it is needed. It came with screws of all kinds to facilitate any assembly with any joystick.I am very satisfied with it.

Every part needed included, proficient installation guide. Highly recommend✔️

This HOTAS desk mount is well made and decently sturdy, which makes it a good choice in it's price range. My only complaints are that mounting a screen or StreamDeck as shown in the listing is unintiutive and requires more parts than those that come with the mount, and that the mount has a small bit of wiggle when compared to some other more expensive mounts.Besides those things, the mount is great, and I'm sure I'll get a good amount of use out of it.

Let’s start with packagingBoth sets of nut bags broke open and the package was full of loose hardware. Annoying but oh well.Then I tried to put the thing together. It’s trash. Can’t get the throttle on because someone decided to include giant wing nuts that interfere with the other pieces. The throttle mounts aren’t well supported so it sags. The design has massive alignment issues. Adjustment is all done with t nuts which is fine once it’s together but absolutely a nightmare.Probably going to be a return.

I was surprised at just how heavy these are but they are definitely sturdy. Was a little difficult to put together cause the instructions are just pictures and it was a little difficult to interpret cause they were a little too small but after some trial and error I got the first one figured out and the second was a piece of cake. Definitely recommend these if you don't have a lot of room like me to have a better setup. I just move my stick and throttle off to the side to allow my chair to slide up to my desk

I bought this mount for use with my x56 HOTAS. It was difficult to put together with the way it was constructed. There are small nuts that must be slid into place inside of rails on the main support and held in place while the outside mount is screwed into them, it sounds simple but it is quite difficult. Also, the edges of every mount provided are very sharp, and being that they are attached to my desk I have torn my knee open on them more than once. The mounts also tend to come loose at every joint causing my hotas to become loose and wiggle around while in use. Overall I would not recommend this product.If you're willing to deal with all of that, the desk clamp on this mount is superb, with a piston lever and pad you can adjust your clamp to the width of your desk and move it around at will very easily. Thus far this is the only part of this product that has worked well.

This mount is made of quality aluminum extrusion and comes with all of the parts and then some to get set up quickly. The instructions were easy to understand if you need them. It's incredibly sturdy, this is by far, the best HOTAS mount you will find, especially for this price. Well done!

For what it advertises, it’s exactly what it describes. It was a bit thicker and longer than I thought. However, that’s due to my low table and long legs. So if you got long legs or a low table, this probably isn’t for you. Otherwise, it’s easy to assemble and disassemble.