Uncle Mike's QD Quick Detachable Super Swivel 1391-2 for 1" slings , Black

Fits perfectly

Easy to install and fit perfectly. Look good in place and are secure to gun and sling.

Can’t beat Uncle Miks’s sling mounts for quality and price. You need a good sling on your weapon- and this is an easy diy job, folks…you can do this with a steady hand drill and good gunsmiths torque driver set. Hint- hold the magazine clamp tightly (I use a small brass clamp over the barrel) and just snug the screw closest to the mag, then tighten the “jack” screw to the spec in the instructions that come with the set. And put a little wood glue on the threads of the stock mount- it’s not supposed to ever come out. After the glue dries, seal the wood finish around the drilled hole with wood floor wax.

4 1/2 stars! The product works as described on both a Marlin 1895 45-70 CBA and a Henry Big Boy .357 magnum lever action rifles. It fit the Henry best. There is a gap on the Marlin model, however following the instructions it does fit properly with patience on installation. The front swivel sling may be the weakest kind of mount of it's type, but it has held securely as I don't put it in abusive situations from handling. The parts are tiny and I dropped the retainer space thing for the front mount and took a while to find it on the carpeted floor. I have to use reading glasses. Otherwise installation was a breeze - again you must follow instructions. With the Henry rifle it is flush all the way and no space thing is needs for a firm grasp of the ammo tube. I do recommend it and am buying another.

I used this on a kel-tec SU-16c and it fits nicely. If you own this gem of a gun then you also know it’s sling set up is nonexistent. After being completely unimpressed with the sling adapter kit I purchased from Kel-Tec’s website I stumbled on to an obscure forum post of someone using one of these for a front sling post mounting solution. I tried it, it works. Hope this helps someone.

Very easy to use and will be buying again!

This particular Uncle Mike's sling mount kit is the easiest way to add a sling to the Hatsan Striker 1000 (x or s), even the Edge. All have the same barreled action. I measured the .22 caliber version's barrel @ .628". The ID of this kit's barrel clamp is .630". Perfect size to make short work of Hatsan's short-sightedness. You just need to drill a hole the same as the pitch diameter of the sling mount screw 2 1/2" in from the edge of the lower butt stock and you're good to go! The Striker 1000x's barreled action seen here being custom mounted in a Hatsan model 95 stock being chopped and fitted to the 1000x action. The clamp would need to move forward 1/4" on the factory 1000x stock. Fit and finish match the finish on the rifle very well indeed! I highly recommend this kit for all you tinkers out there!

As with several of the other reviewers, the screw connecting the two halves stripped. I read prior reviews and used a good hex wrench but it still stripped just prior to me obtaining the required tightness. When the screw stripped I could still twist it on the barrel with minimal forced. I was able to make it work by sliding a piece of pipe over the barrel and gently bumping the band down towards a thicker part of the barrel. Great product but it needs a stronger screw.

solide

These fit my Henry 44 mag and 30/30 also my 35 rem.

Fits Perfect. Exactly what I was looking for.

Seems to be good, will see when I use them

Allen screw is made of very soft metal. Be very careful when tightening as screw will strip. Otherwise excellent product for the Mossberg 464.