Supplying Demand 8544742 1180047 Clothes Dryer Blower Drive Belt Replacement Model Specific Not Universal

I thought sure, others cannot get it to fit but I'm an engineer.And I liked the price at a fraction of the real part cost.So much for that line of reasoning.There is no way to get this to fit a Whirlpool Cabrio 7300 series dryer fan.The belt is marked with the correct Whirlpool PN, but....And I had the same problem with the belt for the drum drive belt.Two strikes for cheap suppliers.

Didn’t fit my Maytag MGDB400VQ0

Used as a replacement dryer blower belt on Whirlpool WED8600YW0. Fit as described and seems to be a quality belt. Working well so far.

Good looking belt, did not fit, it was too long by like two inches whn you measure it. compared to my old one that I put back on for mean time.

correct size, good value

Easy to install

Purchased for an older Maytag dryer. This is the blower belt. It worked as it should.

Luck my Maytag on the belt side of the blower motor on drum belt side had a 7/8 " fitting otherwise with no tensioner its impossible to fit the new tighter bely on bare handed! I took my socket with a long extension to clear the dryer rear panel and got the belt first on motor shaft they once on there, turned the opposite end with the ratchet in the direction that was easiest to where I could pull belt towards the motor pulley and turn the bolt slowly until my belt was on. Mine went from the blower which was vertical to a horizontal motor pully make sure grooved side is facing both pulleys and its clearing properly any objects that might wear the belt! I ran dryer with back only held by 2 screws and made sure it didn't fall off then fully re-assembled the rear cover fully. If you need to take photos and watch on-line videos there is plenty of them on the web!

merci