Nuk3y Door Saver 2 Hinge Pin Stop for Residential Doors Fits All 3 to 4-1/2 Hinges (Oil Rubbed Bronze) by Nuk3y

Once I figured out how to adjust it properly it has worked perfectly. Took my 2 minutes of just guessing it to get it right. The wife asked me to find some directions. I didn't need them lol.

Thrilled to find this simple design works so well. Easy to install. the two stoppers hit the hinge, not the door or trim, of my front door. Doesn't have a hard stop, more of a slow stop that could be moved a few more inches if someone pushes.

Works as expected. Might not stand up to a lot of hard abuse, but we’ve had it on our bedroom door for 6 months and it’s done very well protecting the wall from the doorknobs knob.

Poorly designed piece of crap. Doesn’t’ match typical door hinge pin so it’s sloppy and the adjustment spline is not fine enough to adjust where you need it. Either too much or not enough. Find another product.

The concept was great, and I was looking forward to a discrete solution that didn't put dents into the woodwork. Unfortunately, I found two issues with this: - First, while it says that it works with hinges from 3" to 4 1/2", the pin is over 4" long, so unless you have 4 1/2" hinges or you're will to bust out the hacksaw, the pin is going to protrude out the bottom of the hinge. - Second, and the reason this is being returned is the angle setting. There are 16 teeth on the mechanism that allows you to set the stop, which seems like it should be plenty. But when you do the math, that's 22.5 degree increments, which is pretty big. In my case, I found that either door was too far into the bathroom, or it could still hit the tub, rendering it useless. So unless you get lucky, or you have a decent amount of leeway on what angle will work, there's a good chance you'll be disappointed.