ENERLITES NEMA 6-30P/50P Straight Blade Angle Plug, 30/50A 250V, Black

In service 4 months. Use to make a 220 VAC 50 A extension cord for my welding machine. Seems rugged and durable enough for my use, I do not plug and unplug it that often.

Works how it should turned some old welder cord into a extension with it super cheap but should hold up very well!

This thing works really well, and isn't bad as far as attaching to the end of a cable.

Not all Nema 6–50 plugs are made equal. This one is superior than all the others I’ve ever used. I’ve wired up dozens and dozens of 50 amp plugs for welders and this is the nicest internal components. I have seen solid design.!!!

Good quality and sturdy

Great I order a heater and didn’t have to the right plug. This plug was just the right fit. Easy and good quality.

Wiring a 10/2 wire to the prongs went fairly easy with a tight screw down fit. Matching the two halves together was a bear to accomplish because of male and female mating pins in the housings must lock together before you can tighten the unit halves together. The wire prongs are practically impossible to set in alignment so the halves can be screwed together. My recommendation is plug the male half into a powered-off female receptacle first, which aligns all of the wired prongs, then it is easy to place the other half in alignment and screw everything together for a nice tight fit.

Here's what I did that makes installation much easier 1. Completely remove all 4 Back screws and 2 Front cable clamp screws 2. strip wires, open prong clamps, insert wires and tighten pin clamps 3. Install cable clamp but barely insert the screws. This is important. If you clamp the cable down at this point it will be VERY difficult to install the back cover 4. push the pins toward the inside of the cover so that they have some wiggle room. You need to be able to wiggle the pins around in order to line up the brass ends to fit into the plastic holes of the back cover. once you get all the pins aligned to the holes you can push the two body shells together 4. tighten the 4 front screws and then the 2 cable clamp screws. The back cover alignment holes keep the pins sturdy. This seems to be a sturdy connector and the price was good.

Excelente alternativa para conexiones de estufas eléctricas, recuerden utilizar cable de calibre 8 para evitar accidentes