Kicker 43CST204 3/4" Titanium Dome Cs-Series Car Tweeters

I used as replacement for tweeters in Jeep Wrangler 2014, I did not use the frequency filter, I just cut off the stock Tweeter plug, pulled the cable out through the side panel, slid the back piece that screws on the back of the speaker which holds it flush, put wires back through the tweeter housing, cut off the tips on the kicker wires, soldered the wires together, i tested yellow to black and purple to black, both sounded the same to me, I ended soldering yellow to black wire, slid the shrink wrap over the solder, wrapped in black tape, then the hard part is screwing the back piece through the side panels small opening, once you get it going on the thread it's easy to screw with one finger, maybe you have smaller hands or a kid to lend you his lol.... Anyways... Very loud.... Very clear compared to stock.... I'm not sure if i needed to install the frequency filter that came with the tweeter but sounds fine to me without it... UPDATE: I added the frequency filter, now it sounds very clear, without it it's more loud but crunchy, definitely add it in line.

Installed these in the stock "tombstones" that stick out of the dash to replace the factory tweeters that were blown in my son's 2012 Jeep Wrangler. The install was a little tricky because I have large hands and you gotta squeeze them into the dash from the sides to screw the "nut" onto the speaker from behind. It wasn't a horrible job tho and didn't take too long. Total install took less than an hour. No modifications to the dash or the speaker housing was needed. I used a plastic panel tool to pop out the stock speakers but you could use a knife. Cut the stock wiring harness plug off and wired up the new speakers WITH THE INCLUDED CROSSOVERS and they sounded good with no more popping! A week later we installed an Alpine Touchscreen head unit with Carplay and now they sound even better. Now we are going to upgrade all the stock speakers to the Kickers because the factory speakers in the Wrangler are garbage.

These lil tweets are very crisp without being harsh. They come with various mounting options, screws, barrel splice connectors, inline bass limiters, and are literally Sailor Proof on the install. They arrived extra fast and were a Christmas gift from my wife to me since the crappy Rockford speakers my car came with had blown out a few months back. These with the 6x9 CS (doors) and the 6.25CS (rear) made my 06 Eclipse sound amazing again. For the other speakers make sure you get some baffls (boom mat) to make your stuff sound really nice and rich. These are definitely money well spent and did not clip or crack at all when pushed to reasonably loud volume (I listen to a lot of FFDP and Sabaton).

Excellent quality set of tweeters with many different mounting options included. Sound is very loud and doesn't require an aftermarket amplifier to take full advantage of it. The included crossover is a nice touch, to ensure that only the proper sound is being emitted from the speakers. Only downside is that when mounted in-dash facing upwards, the tweeters are too loud and cause harsh high tones (probably because of the reflection off of the windshield glass). Had to add a dampener on-top of the speakers, which looks funny but solves the problem. Overall, these little speakers are quite loud and reasonably priced. Next time I would mount them under the dash and keep the standard car tweeter grilles above them to reduce the harshness.

I bought these to replace my stock dash tweeters on my 2013 Jeep Wrangler Sahara they sound nice and crisp, You can use the factory amp if there is one or you can run them to an aftermarket amp. just make sure you keep the pre-installed in-line crossover (unless using a digital crossover for each channel) the inline crossover is a resister which will restrict some of the power to it, but If you don't run a frequency crossover on this tweeter, Which they will either 1. sound horrible if you hear anything at all 2. toast them with the lower frequencies (even worse) you'll be running the full range of sound frequencies through them, not the preferred 800-20k, Anyway I love mine!

So far sound better than factory, though they’ve only been installed an hour. Installed in a 2011 Silverado to replace the factory pillar mount tweeters (not Bose). Had to trim some plastic under the factory tweeter cover, but otherwise no problems. Installed in 30 minutes. I didn’t use the supplied crossovers, as I’d assume the factory wiring already has them.

Put thes in he sound bar and dashboard in my 2918 Jeep Wrangler Unlimited. I had to fashion some mounts using 1/4” abs plastic, but not hard at all. These along with the Kicker 6.5” molar replacement speakers made a huge difference in sound. The 6.5” alone sounded heavy, but by adding these tweeters, the high end really comes out. In he dash, they definitely pull the sound up from the floor. Definitely worth every penny.

The version of the speaker, ie the face look, was not as pictured. The version of the one shown is of an open look into the speaker where the one that arrived was not. They are still able to be installed in my vehicle but I was not expecting the look I got.

These are awesome little tweeters! They sound great and look great!! I've always loved Kicker! I put these in a 2009 Honda Accord sedan :)

Un vendedor muy malo, manda el producto que el quiere y no el que se le pide. Aparte de que el embalaje es de mercado libre y nada que ver con amazon. Aparte de que tardan años en reparar su error pues tardan mucho en hacer la devolución

Really good tweeters

These sound great with my system (2 10" subwoofers, 2 4x6 mid range door speakers, and now these). They were stupid easy to install, although I previously had tweeters, but they were cheap and blew up at high volume.. Sound quality went up big time after adding a pair of these!

Great sounding over stock, easy to install!