SlickMod PreCut Vinyl Smoke Tint for 2021-2022 Ford Mustang Mach-E Sidemarkers & Reflectors (2. Sidemarkers & Reflectors, 20% Dark Smoke)

This is my second set after I traded in my Premium for a GT. Both are really easy to install if you do it the same way as a phone screen protector with some soapy water. I also used a heat gun at 350 to help it go quicker. My second set also came in for the wrong car and the seller fixed it really quickly and without hassle. A++

No problem installing these on my 2022 MME CR1. Prep and install took about 45 mins, probably because I have little experience. Didn't need to trim any excess film.Only complaint of the kit did not come with a felt card. I put ppf (another company) on my door pillars, and that kit had card and small water bottle, everything I needed for that task.But no real problems and it looks great.

This cover up is exactly what the Mustang Mach E needed. It should have come this way from the factory, it looks that great!

This is a perfect fit for your black light lens. You will need a hair blow dryer to heat up the vinyl before and during the institutions. Without thr hair dryhair the vinyl will be difficult to shaoe to the lens. Also you need to use a lot of soapy water to get all the bubbles out.

These were a pain to put on and kept sliding out of place, the curves of the light was probably to blame, but when I did finally get them to stay in place, they did not cover the entire area that you would expect them to cover.

A sheet of uncut tint would have been easier to install.

The taillights on the MME are flush with the surroundings, so you can't fold these over the edge of the light. Therefore, they must be perfectly cut, else you'll see the edge of this film. Since these are not cut to match, you see the edges of the film past the light. I suppose you could carefully get a razor and cut the film...but I'm not doing that. No good.

The pieces did not fit properly and I couldn't get them to stay in place.