⚙️ Power Up Your Projects with Precision!
The HiLetgo XL6009 Boost Module is a high-performance DC-DC adjustable power converter that efficiently steps up voltage from 3.0V-30V to a wide output range of 5V-35V. With a 400KHz switching frequency and 4A output capability, it ensures minimal ripple and high efficiency, making it an essential tool for any electronics enthusiast or professional.
| Manufacturer | HiLetgo |
| Brand | HiLetgo |
| Item Weight | 2.08 ounces |
| Package Dimensions | 4.65 x 3.23 x 1.22 inches |
| Item model number | 5841863421 |
| Is Discontinued By Manufacturer | No |
| Color | Blue |
| Number of Items | 5 |
| Size | Small |
| Manufacturer Part Number | 3-01-0101-5pcs |
S**T
These work great, but...
These work great but if your trying to turn 3.7v into 32v they get very very hot. So make sure you have a heat sink, or change your setup to get as close to 30v as you can which causes less stress on the board and not as much heat.
H**I
They Work and Input Output Polarity are Clearly Labeled
My Particular Use: Boost 12vd to 26vdc for operating a Transfer Relay with 26 vdc coil voltage. 26 volt relays are readily available surplus and are much cheaper than 12 volt relays. (Requires a snubbing diode at the output.)Pros:Clearly marked circuit board and solder terminals with both input and output identified and polarity of same.Bourne Multi-turn potentiometers are of good quality and make adjustment smooth and easy.No apparent noise generated to my ham radio receivers. (always a potential problem with switching supplies)Very inexpensive, at about $2 unit cost, 5 supplied in the package.Provide up to 4A current ...way more than any relay I would use requires (typically < 200 ma.)Cons: I can't think of any. They are perfect for my applicationBe sure to measure and set the output voltage appropriately for your project BEFORE connecting these modules to any equipment!
L**A
Great boards but see review
The boards work great at boosting voltage. But, had some slight problems with amperage. You can buy a dzs elec dc to dc buck converter.
F**I
Not isolating.
I used it to raise the voltage from a 5 volt 1 amp fixed power supply to 7 to 15 volts to test LEDs. The input and the output were both isolated ( not connected anywhere) so no issues. The - input is connected directly to the -output.As with any device, there are restrictions on voltage, currents and power. It is spelled out in the spec sheet.
C**R
NOWHERE close to spec
Description advertises output voltage range from 5V to 35V and the ability to handle 4A.With 3.7V on the input, the output V-oc (no load) came up at 50V. With the adjustment pot all the way down, I could only clamp some down to 15V Voc. With a 50 ohm load, some regulators could only clamp to 6V but only source 100mA. Other regulators, with that same 50 ohm load attached, couldn't get above 3.5V. Input power never exceed 1.5W @ 3.7V according to my bench supply. These regulators behave like they came from the garbage bin.DO NOT BUY!
Trustpilot
3 weeks ago
1 month ago
