Question 1

Why are almost all of the 5 star reviews from people that have only reviewed this item? That is amazing.

Accepted Answer

I almost purchased a Lotos welder awhile back but as I read the glowing reviews I found many were written in the same manner and by persons with no other reviews under their belt.  Did some research and concluded most were fabricated . I would use caution in evaluating this machine based on Amazon reviews.

Question 2

what is the difference between the ltp5000d and the lt5000d?

Accepted Answer

Hi, Michael:The LTP5000D is a pilot arc plasma cutter, that means the torch do not need to touch with the metal you want to cut. However the LT5000D do not have pilot arc, the torch need to touch with the metal you want to cutter. Pilot arc torch efficiently cuts though rough, painted, and rusty surfaces and produces minimal slagIf you choose LTP5000D you can spend less money on change the consumable for your plasma cutter. Thanks for your inquiryRegardsLotos Technology

Question 3

What amperage circuit breaker is needed in my panel for 220v operation? 120v operation?

Accepted Answer

i am using a 60 amp breaker on the 220 v circuit.  at 120 v the cutter will kick out a 20 amp breaker if turned up over half power. i haven't tried using it on a 30 amp/120v circuit. But    have used it at full power on my 220 v circuit with no problems.......

Question 4

What is the minimum size compressor (tank size) that can be used with this machine?

Accepted Answer

I found it on the Lotos web site in the manual. The CFM requirement is only 3.8. @ 66 PSI. A small compressor should do the job. Tank size will not matter if you have at least these specs.

LOTOS LT5000D Plasma Cutter, 2024 Upgraded 5/8 inch 16mm Clean Cut 3/4 inch 20mm Severance Cut 50A Plasma Metal Cutter Machine, Plasma Cutting Equipment, Dual Voltage 120V or 240V, Brown

Description

Specifications

Common Questions