PLA Plus Filament 1.75mm PLA+ 3D Printer Filament, +/-0.03mm, 1kg (2.2lbs)/ Spool, Gray

I was happy to get this since I already had a purpose for this Orange PLA. When I tried to make a temp. tower and do the basics, as I do with all of my filaments, I could not get this PLA to stick to the bed. I tried all different filament temperatures, checked my bed level (spot on) but, either during the first layer OR as soon as the second layer started, my print was being dragged around the plate and there was a 'small helping' of spaghetti forming. I was about to give up when I decided to raise the temp on my glass bed. I normally run all my other PLA's at 60 deg. C and I bumped it up to 65.... No joy. I then tried 70 C and viola, it stuck. I have done many prints today and as long as the bed temp was 70 deg C no problem. I have settled on 205 C for the extruder temp, which makes for a nice smooth print.Just so I don't throw anyone off, I have a stock Ender 3 V2 with the stock glass bed BUT I use the smooth side. I have never used the textured (proper) side. I only use Windex to clean the glass before most prints unless I'm doing a few short prints back to back. I went the whole nine yards trying to figure out how to make any PLA stick and I had tried using 99% rubbing alcohol (Isopropnol). I could see under the right light that the alcohol was leaving a slight film and then nothing would stick. Once I washed the bed with soapy water and then used some Windex everything has been sticking perfectly without any other glue stick, tape, hairspray etc.PROS:-The colour of Orange that this filament has looks really good.-No tangles at all and the spool is wound very well-Price was great and shipping was fast (at least for Canada)CONS:-Nothing, now that I've been able to get it to stick!

Un PLA+ excelente, facilísimo imprimir en cualquiera de sus rangos de temperatura como en las pruebas realizadas. Se adhiere a la cama caliente sin ningún problema perfectamente. Destaca una resistencia por encima del Pla convencional y un color buenísimo. Un embalaje al vacío y el bobinado óptimo. Repetiré sin dudar.

I gave this multi pack of pla a try since it was cheap and I needed to run some prototype prints in various colors on my Monoprice Mini Delta 3D printer and I am thrilled with the results! The silver in particular is fantastic. The rings I’ve printed out with the silver come out looking like iron. The small amounts in this variety pack are perfect for my needs since each print I run only uses about 1g of filament.

La primera impresión horrible. Viene retorcido sobre el propio eje, por lo que roza con el tubo de teflón y aparte el bobina parace hecho con el culo. Probaré a imprimir un cubo, xo pinta a devolución inminente

This filament is really beautiful. The tolerance is 0.02 and prints at typical pla temps. Packaging is excellent with a full label on the front and lots of openings in the back to see exactly how much is left! Many of the rainbow filaments have been criticized because they don’t transition the colors often enough but this filament has lots of frequent transitions! Prints great so if you’re after a good filament at a good price then check this one out.