StoneBanks 10 m Pressure Washer Drain Pipe Hose Cleaning Kit Replacement for Karcher K2-K7, Bosch, Lavor,Sewer Jetter Hose with Jet Nozzle 180Bar

This was a perfect product for what I needed and most importantly if fits Ryobi machines!I bought this to clear a driveway drain outdoors that was stuck solid with mud, stones etc. I thought it would struggle but after a quick bit of assemble it made short work of the problem.I fed it into the drain - you have to push and pull it as it dislodges the blockage.The rear facing jets pull the hose further down the drain making sure it was clear. It was good for the tight corners of the drain too.It is thin enough that you could use it to clear indoor sink or washing machine drains too.All in all 10 out of 10 for this productIf you can unroll the hose for a while before you use it, it will help speed up the job.

Fast delivery and great quality. At first I thought it wouldn’t be compatible but then realised (doh!) it attaches the jet handle and the washer. Was then up and running with 2 or 3 minutes. I had a properly blocked domestic drain. Filled with yuck and somehow (kids!) what seemed like a roll or two of kitchen roll! Very nasty job but I persisted and within 40 mins it cleared the main drain from the house to the street! Very pleased with my purchase. Oddly, I only figured out that it was fully compatible after I’d requested a return. Seems so obvious that it fits the gun bit in hindsight. Should have looked at the product photos which do show that. Great bit of kit, happy to fully recommend 5 star review well deserved.

It took a lot more effort than I expected to clear the blockage caused by years of silt build up primarily from minor erosion of my roof tiles. The main problem was the tiny jet holes blocking up because of the fine silt - a pin easily cleared them but it all added to the time to clear the blockage. But.... it did the job and fitted my karcher easily

Worked well; Handy with extra connector bits.

cleaning gutters did the jobl

Bought the 10m version to clear the old cast iron pipe from a slow draining kitchen sink. Over the years a lot of internal corrosion had allowed debris to build up in the pipe. This amazing little item removed all the loose rust along with lots of gunk and the sink is draining perfectly now. As one of the other reviewers said, it’s most effective if you keep pulling the hose almost out to help flush the debris, and then allowing it to propel itself back in again for another go. I have a Work Zone pressure washer from Aldi and the Lavor fitting is an exact match. The hose is a little bit stiff but if you uncoil it in a straight line first it will make things easier for you. Thoroughly recommend this item!

I've just unblocked the drain easily with this snake. I connected it to my TITAN TTB1300PRW (the cheapest one from Screwfix) using one of the brass connectors supplied. I used a few wraps of the included PTFE tape around the threads of the connector and spray head. There were no leaks. I fed the snake into the drain and turned on the washer - it didn't propel itself strongly as shown in the product video, but I was using a fairly low power pressure washer so your mileage may vary. I just pushed it further along the pipe until the water started turning grey, then after twenty seconds or so, the clog released! I washed it back and forth along the pipe until the water ran cleaner. Job done!The snake feels like a good quality item, at least as well made as the fittings that came with my sixty pound pressure washer. The price feels right for the successful DIY drain unclogging.

This doesn’t work with the K2 pressure washer.Maybe it does work, but without instructions I have no idea.