SnailflyBlack Crossbars Fit for 2011-2021 Jeep Grand Cherokee Cross Bars Roof Rack Luggage Holder Aluminum Alloy with S-Steel Clamps

I put these on my Jeep Grand cherokee, they look fantastic, very streamlined and fit perfectly. If you have the finned antenna on the back roof these racks are about an inch or 2 lower than the antenna, so you wouldn't be able to fit a flat sheet of wood along the top of your truck without it hitting the antenna.They are relatively easy to install if you some mechanical ability, I took one side of the bracket all the way out and only loosend the other side enough to put in the grooves. The rubber feet I think were the hardest to put on but still not bad. Probably took about 40 minutes to install it all.I haven't put anything on them yet but they seem to be good quality and very sturdy.

Très satisfait

Seems like decent quality and looks good. It is a bit of a pain attaching the screws since they are on the bottom of the rails and give you no room to tighten them up. So take your time and have a helper if possible. A little blue loctite helps as well

I choose these because of their streamlined looks, low height and I did not want the bar extending pass the rails, I wanted an OEM look. These look great and pretty easy to install except for the screws underneath. Use a mirror or your phone camera to view the location of the screws. Makes it way easier to tighten. Also, I did not use the rubber gaskets. I thought the install looked better without and is more secure without.There is a slight, barely ( you rarely have to listen for it) audible whistle when traveling 40-50 MPH. However, at higher speeds nothing. Don't let this stop you from buying

Very disappointed because I liked the low profile look of these crossbars. The rear crossbar was not wide enough... fell about a quarter inch short so the locking bracket was not secure on the rail. The front crossbar is longer and the rear crossbar is shorter as its supposed to be, but this one was TOO short. I even extended it as wide as it'll go with the screws.All of the end brackets were stamped “front”. Front left-hand and front right hand. None of them were stamped ‘rear. Not sure if that would make a difference because it's the cross bar that needs to be longer, not the end bracket.Stinks because my trip is in the morning and I'm just finding this out now… so I'm stuck. I can't take a roof rack with me so I need to leave items behind.