Airwolf 3D A14200 WolfBite Nano Premium Heatbed Adhesion Solution for PLA, 2 oz.

This stuff is absolutely AMAZING!!! No more failed prints due to lifting!I apply this to my heated glass bed, and the print STAYS STUCK until the bed cools when the print is done... Then it pops off as it cools. ;-)

It works most of the time. I have to put my bed in the freezer for 5-10min and it pops off perfectly! Don't rinse it off like they tell you!! You can wet the application brush and use it to reapply whats already on your print surface (will save you a ton of wolfbite).It looks like it struggles with long and narrow prints though. I made a bottle last almost a year! The bottle says it expires after 30 days? That's a complete lie on Airwolf's part because it works the same after that. Also Airwolf support is pretty bad, I rarely get a response. I would still recommend this over other print surfaces like PEI and others because it's cheaper to buy this once or twice a year versus replacing a print surface.

It works but can become undone every once in a while and it takes long to dry and apply coats. But otherwise it works!!

Love this product!! Had to make sure I dont run out!

I want to be very clear: This review is for Wolfbite NANO, the bed adhesive for PLA, not Airwolf's original Wolfbite for ABS (which is EPIC).This stuff is nothing like the original Wolfbite for ABS. The original ABS solution goes on the bed about like water, dries quickly to invisible, and is a snap to clean off the bed using isopropyl alcohol. This version is more glue-like, I see no advantage it offers over blue painter's tape, and it's a nightmare to get off the bed once you put it on.

Use this for all my prints. Love it.

WolfBite products are good - not the best adhesion system, but suits very well. Had to put one more layer after each print to do it's job; after each print easily pull out of the bed (is an obvious advantage, but must take care on fragile structures adding skirts to prevent slippery jams).Pro's: clean, soft and good looking (transparent) layer onto your bed; easily pull-out-of-the bed system;Cons: bed must be warm/hot, depending on material (PLA≈50ºC, ABS≈130ºC)

Good for pla