[5pcs of Pack] Nema 17 Stepper Motor,42x23mm 42BYGH Motor 4-Lead Wire 130mN.m 1.5A with 1M Cable for CNC,3D Printer

I had a resin spill on my Halot One Plus resin printer that got into my Z-axis motor, locking it up.I ordered this set of 3, because it was the only 42-48 stepper motor that I could find with fast delivery.This motor was exactly the right replacement. The size was obviously correct, and the old motor was wired exactly the same as this motor. I just had to plug it in and it worked perfectly.I wish that I didn’t have to buy three of them, but I suppose I’m covered in case I have another spill.If you’re looking to replace the motor in a Halot One Plus printer, this is exactly the one that you want.

This worked as a replacement for an ANET A8. However, the wire order was reversed. Needed red, blue, etc., top down so had to change that. I couldn't get the sockets out of the JST connector so just cut it off and soldered the wires to the old connector. Motor working just fine, calibration cube was PERFECT so e-steps didn't even change.

Depending on printer you have you may find that motor is running backwards and have to change blue and red wires or you can change code in your firmware

Los motores sirven excelentemente, pero lamentablemente los cables venían conectados de forma errónea lo cual hacia que pareciera que no funcionarán los motores pero los proble con otros cables que tenía y ya funcionaron, dejo foto del cableado correcto.

Drop in replacement for Tevo Tornado Y axis. Works perfect. Don't overtighten the belt as that will just wear out the bearings faster. Also, dial down (way down) the JERK and ACCELERATION values to keep the mechanical stresses lower and eliminate layer shifts. Great product... will buy from them again in the future as necessary.