Sukemichi Sunshade for Ford Bronco,Mesh Sun Shade Bikini Top Cover Bimini Top...

UPDATE: I was unable to close the soft top with the configuration I installed. The mounting cup placed on the inside bolt where the soft top latches did not allow the pin to fully sit. So I moved the cup to the outside bolt and used the #3 cord in the corner hole of the shade, and used the #2 cord with hook going to where the soft top latch closes. The hook needs to be removed to close the soft top, but not a big deal and actually i can remove it altogether. I test driving on the highway with the #2 cords unattached and there’s no issue at all. See the last pic. I was a little concerned because the pics and video in the description showed 2 front hooks mounting to the hole where the roof pin sits. But there must’ve been an update because now a loop mounts to the round receiver that you put on the outside bolt of the latch area. Installation was easy and I did it with the soft top flipped back in position 1 (rear windows still on). But I had to the the top fully down so I could add PPF over the areas where the large #5 cords lay on the paint. The spots where hooks are used in the front didn’t need PPF because the hooks luckily don’t touch the paint. The pics show how all the mounting is done. I only showed the driver’s side sine the passenger is the same. The second to last pic shows the amount of shade provided. The left side of the pic has direct sun and the right side is thought the mesh. Wind is also reduced during highway driving with the widows closed. Great product and great price! I recommend it.

Love this sunshade. It was easy to install and fits great. The bungees attach very tightly so there's no wind flop. It also gives good sun protection and keeps your seats from getting too hot in the sun and burning the back of your legs when you're wearing shorts. I will say that the instructions weren't very clear on where to hook the front corners. So when I originally put it on, it had wrinkles in the corners. I moved where they attached and it smoothed out. But definitely 10/10 recommend!

Instructions could be more clear, but it is pretty simple to figure out. Fits well, however does leave 4 inch gap in front above front seats. Would have been more convenient if there was either a zipper or access points to put on and take of the t-tops. The hard top and t-tops can be put on over this simply by removing a couple of the clips, 2 on the sides and 2 on the front. Cuts down on sun and prevents debris, but it is MESH, so it's not Sun-Proof. Wear your sunscreen, especially if you're bald like me. The balls on the hooks can be installed above or below she shade...your preference, doesn't seem to affect functionality either way.

It was great! I can see the complaint about the instructions, but I just sat everything out, laid the bungies where they needed to be on the mesh to prepare what it would need to look like and went to town! Was very easy to install. Definitely need patients because if you don’t get it hooked or looped (the smaller bungies) they will fly all over, then the manhunt begins. But just take each step slow. I installed starting at the front and completed one side to get the feel of install then the other side was a cake walk! It turned out great and looks amazing! The bungies are strong and very durable. There is the front gap, but it’s not bad at all, looks like a large gap, but in person it’s not bad. Next step is a good ole test drive!

Fits well and easy to install. No troubles at higher speeds but I have a roof rack with a wind fairing. It stays installed with the hardtop on. You simply have to disconnect two small bungies right above the rear view mirror which iterally takes 5 seconds. It's a bungy bimini so its not going to be as robust as some of the higher end options. But it provides outstanding value at the price point for those who don't want to spend $300+. I'll just buy this one again when this one wear out in a few years .

For real? $38 and it’s better than $150 ones AND I’m able to close my soft top without removing it? What?? Too good to be true. Facts: better material, metal fasteners, no wind noise (from the Bimini top, not the actual wind), easy install, plus American flag? I did this as a trial before I spent $300 on the bestop one…but WOW. Installation: instructions are wrong. You will use all 8 bucket seats (black plastic rings to loop bungee around), but you’ll only use two of their screws and 6 of your own. Easy day. Grab your bronco tool kit and wild out. I have 2022 4 door Wildtrak.

We bought this for our 4 door 2021 Bronco after purchasing a bimini cover that was solid fabric. The mesh design of this one is actually more comfortable to the occupants even though it’s the same color. Heat can’t build up because of the mesh. We live in a very hot area of Texas and this shade cover makes driving around with the top down comfortable even when it’s 100+ degrees. The material is very tough and well made and the securing bungee cords are very strong. I am 74 and have lost grip strength, so getting the bungees around the hardware provided was a challenge. They are VERY tight. I found using a large Phillips screwdriver as a lever to guide the bungees on made that task much, much easier. The installed cover looks great, fits very tight and doesn’t flap even at 70mph. Sure, it’s noisy in the vehicle at speed, but it’s a dang open top sport vehicle….what else would you expect? It doesn’t interfere with the top when it’s put back on, so the shade will stay on all the time.

Put on just fine. Between the instructions and the pictures from reviews my husband and I had it on in about an hr. We took our time as well. Drove around today and it was AWESOME! With the windows up there wasn't much wind, definitely keeps the sun off you.