1/4" Irrigation Hose Clamps, 100 Double Line Hose Pipe Spring Clamps, Drip Irrigation Kit Connector Leak Solution

I never used before, I have sometimes water pressure problems and this helps a lot to don't loose

I don’t know how many times I’ve found a sprayer that cam off its tube. These clamps solve that problem. Easy to slide over the small drip lines BEFORE you add the drip per, then clamp on. I need to use pliers to use them. I am happy not to be wasting precious water by loose or escaped tubes any longer.

Bought them for irrigation connections and they will not fit over the barb of the connections while the hose is on. Tried several different combinations to try to get in on and they will not fit. Hosing I bought on amazon 1/4 inch.Updated to 3 stars as I was able to get them to go on with an extra hand using a flathead screwdriver or a thumbnail to force the clamp over the barb. There is absolutely no way ill ever be able to remove them without cutting them off though. While you have one person holding the hose with one hand and using their other hand keeping the clamp open with pliers you have a 2nd person using their finger nails or a flathead screw driver you can walk the clamp on by forcing a portion of it over the barb and continue doing this around the clamp until you finally have it over the barb. I havent tested to make sure it doesn't blow off but hopefully it holds. Because of how much the clamp has spread from forcing it on there is a section that is being held by the flat part of the clamp. There are clamps available from other sellers just like these that are much easier to get on and will save you alot of time and thumbnail bending.

Had to replace my jet pumps pressure sensor tube. The barbed connectors held fairly well on their own, but I was worried during hotter months the tubing might split. I tried the plastic ratchet connection clamps first, but they just didn’t hold right. One thing to keep in mind is you have to get these on the tubing prior to connection.

These save me from having to find the hose that blew off the connection. Keeps the whole system tight together

Very tight fit. I've used about 40 clamps so far. I've only had one clamped hose to pop off a pipe--not bad at all!!Trick I learned: Before trying to install the clamp, cut the hose at an angle. Makes it much easier to pull the hose through the clamp. Once the clamp is on the hose, cut off the angled piece of the hose then put it on the pipe.

I HIGHLY RECOMMEND GETTING THESE QUARTER INCH PLANTS WHEN YOU PUT IN A IRRIGATION SYSTEM SOMETIMES YOU CAN PUT THE HOSE ON THE ENDS AND THEY DON'T FIT TOO TIGHT OR IT DEPENDS ON HOW MUCH PRESSURE IS GOING THROUGH THE LINES IT WILL BLOW OFF I HAD THAT PROBLEM WITH THESE CLAMPS IT PREVENTS THE HOSE FROM BLOWING OFF THE ENDS OF THE IRRIGATION FITTINGS THIS SOLVE MY PROBLEM THANK YOU FOR THE FEIST SHIPPING I ORDERED THEM ON FRIDAY AND GOT THEM ON SUNDAY AFTERNOON AND SUNDAY AFTERNOON AFTER I GOT OUT OF I PUT THEM ON MY LINES AND THEY WORK GREAT

These clamps are absolutely essential for any irrigation system. They should be included with any irrigation kit.