Jet Ski Dolly Cart, PWC Stand with Adjustable Carpeted Bunks

I wasn’t sure what to expect but this stand has been amazing it’s a good quality item and it rolls effortlessly, 3” lower would make it easier to work in the engine compartment of the sea doo

I’ve read a lot of the 1-2 star comments and have a hard time believing some of the reviews. This is adequately built and felt solid after assembly. Instructions were more than good enough to properly assemble it. One of the reviews said the instructions were bad and another one blamed the bolts for the caster being too long. But really, if you’re mechanically inclined and have critical thinking skills, putting this together is easy. The bolts for the casters do point upwards or it will not clear the wheels but one of the reviews blamed the instructions and then they figured it out. Well worth the money. Unless this dolly buckles under the weight of my Waverunner FX SVHO, then my review should tell you all you need to know.

4 1/2 stars.. Holds at least 1,000lbs fine - 900lb jet ski and me on top of it. Rolls around nicely and feels sturdy. I have a flat concrete floor (garage) to roll around on. I don't think I'd take on it something too rough, such as a pebble concrete. My only complaint is that I had to under to the bottom bolts of the support and turn them up to get an engine lift under it. They are perhaps 1" too low. While I had those supports only tightened with one bolt, I did not move it around.

A breeze to put together, sturdy strong, performs well, the caster wheels could be a bit larger, but all in all this thing was a great buy !!!

Completely satisfied. Sturdy. Holds my 2001 Yamaha XL800 no issues. Casters lock and hold well also.

Never bought a PWC cart/dolly before. Was shocked by the price of others and after reading reviews I went with these. I bought two and I can say I’m satisfied. I will say the only real flaw is even with the reinforcements you can still over tighten bolts and crush the square tubing, ESPECIALLY THE VERTICAL BOLTS. If you crush the tubing by over tightening you could compromise the strength of the cart/dolly and it does not mention this in the instructions so just be warned. Only other thing that could be improved besides that and a little more detailed instructions is all of the bolts, nuts, and washers come in one package and are unsorted, not a huge issue but I found it annoying. This product will take you about a half hour to unpackage and assemble, only tools needed are 9/16 and 1/2 sockets and or wrenches. I also wanted to mention I have two 1999 Sea Doo GTX pwc’s and I had to assemble with the bunks at maximum width. I think these carts could easily be used for other purposes with little modifications as the top of the main frame is flat with holes pre drilled. Hope this review helps.

Easy to assemble, solid enough to do the job... obviously not the best quality. You definitely get what you pay for. Just be aware you can easily over tighten bolts and bend the metal inward. It’s a good value for what it is, which is a cheap functional jet ski dolly. The wheel locks do work great, and it rolls nicely.

So far so good, holds my 2021 yamaha vx deluxe with no issues. Welds on square tubing look good, wheels roll and lock good. Ski stays sturdy on dolly. Seen the same exact ones on ebay though for $89 or make offer with free shipping, will get the next one from there.

Seems fairly solid the brackets that the boards mount to the frame could have been little thicker ( just my personal preference), but still pleased with it