GPU Support Bracket, 4.73" GPU Support PC Graphics Card Support GPU Stand Anti GPU Sag Bracket Video Card Anti Sag GPU Holder Mini GPU Mount for Prevent Universal Graphics Card - Adjustable Height

Works great and did exactly what I needed it to. Due to my case design gpu sag is going to happen, this just stops it from getting worse. Highly recommend

I have a NZXT H7 case for my new build, the 5080 FE is only 2 slot width and the case is super high from the bottom, I tried a few GPU supports, this one is the only one that fits (just enough).

This is LONG - I didn't measure before I purchased, but it was much longer than anticipated. It ended up being totally fine for what I needed - and I'm going to keep the product - I would say definitely measure what you need first.The only reasons I gave it 4 stars are because:1) no magnet - the other one that came with my 5070 has a strong magnet that will definitely keep the support in place attached to my PSU. This one has a soft pad on both sides - which is probably good for vibration control (?) but didn't feel the most sturdy when installing.2) the knob to lock the height is super big - i mean like way bigger than the diameter of the actual product itself. It sticks out kind've like a cartoon. I was expecting something a bit smaller and stylish. I remidied this by turning the support so the adjustment knob is facing inside of my pc and I don't have to look at it.

This is Truely a great piece of Equement to have in your PC for your GPU,it's high Quality well machine

These are small, adjustable and well made. I was able to add them under my 3080 in all the spots were support was needed. They blend in well (with my build) and did not distract from the aesthetics.The only thing I found to ding them on is the screws. They work fine, but there is no way to "set" them and they can loosen over time. I assume from vibrations from the fans? You could add another nut to lock it in place or just use some Loctite. Either one is a very simple fix.I will use these again.

I am using this with the new (2024) NZXT H7 Flow RGB case. It does exactly what I need it to do. The case has a lot of room, so I needed a big GPU support bracket to reach my GPU from the bottom of the case.

Upgrading from a short and light GTX 1060 to a longer and heavier RTX 3070 came with the dreaded sag that made my setup look lopsided and could have led to damage. What I like about this support brace is that it is much longer than other options on Amazon. I needed it to reach from the floor of my case to the graphics card, and this was among the only ones of its kind that would be able to make the distance. Installation takes little to no time and instantly improved how my system looked. My card was not droopy at all. This is a no-brainer for anyone who is experiencing any sag at all and is a cheap solution for something that can turn into an expensive headache.

Not sure I even needed it but it's great peace of mind knowing my card won't sag over time. Only possible complaint would be that it's not a little smaller to begin with but that's my build more than anything causing that.