Evolution Power Tools RAGEBLADE 7-1/4-Inch Multipurpose Cutting Blade for Steel, Aluminum, Wood and Plastics

Sorry, I have shipped wrong Item. Evolution Cutting blade is good.

Works as expected. Direct replacement for my rage saw. First cuts on 1” square steel. Other cuts on 3/16 steel and 1 5/8 round tube steel. I hook my shop vac to the saw but it still make quite a lot of metal chips to clean up. Definitely will buy again

Sharp and quality made

I've bought a few of these. They're great for clean metal. Lots of fast clean cuts. But you can ruin them cutting rusted drill stem or cutting at severe angles without a plunge cut to start.

This is a very good blade that goes well with their (admittedly) cheap metal saw. it worked great and lasted quite a while. After it dulled down a bit, I sent it out to be sharpened. While it was gone, I bought an upgraded Rage metal-cutting blade (with twice as many carbide teeth). That one also worked great, but after about 15 minutes of use, my saw quit working. I discovered the brushes in the motor were shot. I replaced them with the spare set that came with the saw. These were also done after another 15 minutes of use. By the time I got the brushes replaced again, the original blade was back from sharpening. I reinstalled it, and no more brush problems.I think all that extra carbide was putting a load on the saw motor it wasn't designed for. This blade is perfect for the saw; you can't improve on it.

Replaced an abrasive cutoff saw which croaked with a Rage saw for cutting 1/16"-1/8" aluminum extrusions and 1/8" cold rolled steel shapes. This is my 3rd blade. But the blades last a long time before going dull (Lots of sparks and very little cutting.) But for speed, it's great! Just keep the revs up and don't push too hard. And wear hearing protection.

I mean, it’s a great blade that lasts about as long as that zebra gum from the 90’s-00’s. I can 100% say it is not “Perfect for laminate” because I’ve gone through 2 blades doing 500 sqft. I’ve also done construction my entire life and maintenance professionally over a decade so I know how to put a blade on.

I cut a lot of aluminum and a lot of plywood. This blade does both very nicely. When (if) it ever dies I will buy another one. I have one of these on my track saw, one on my chop saw and one on my table saw - that is how much I love this blade.

ES UN DISCO MUY BUENO LO HE ESTADO UTILIZANDO OARA CORTAR MDF Y DEL TIEMPO QUE LO ADQUIRÍ HASTA EL DIA DE HOY SIGUE FUNCIONANDO MUY BIEN

Muy buen disco, para varios materiales., bien utilizado dura bastante

Corta muy bien muchos materiales, pero una de más dientes cortaría más fino, o bien usar con muchas revoluciones

excelente hoja de corte multi material para sierra de inglete

Después de perder el filo de los dientes los volví a afilar y quedó con buen desempeño. Muy recomendable.