V-Tech VT-153 Quality Copper RTV Silicone Instant High Temperature Gasket Maker

I used this for a couple of joints on my exhaust before putting new clamps on as I don't like the usual exhaust paste that places lile halfords sell. Was recommended to me to use this and so far so good only been done for a day or two but for now I can't feel any air leaks and this product is nice and applyable however the tube could be better you have to squeeze pretty hard to get the sealent to come out and also its a shame about the colour but at the end of the day it is under the car I guess and you dont see it. So I'd give an 8/10 all in all for this product I'm happy enough and would buy again if needed.

The gasket on my Kamado Joe ceramic oven was detaching from the ceramic, and after a lot of research I tried this product. I know it's meant to be an automative product however forums suggested using this type of compound. In engines there will be a very thin layer, but repairing the Kamado needed it to be used like toothpaste. It has very low tack when un cured, therefore you need to re seat the gasket a step at a time- I did it in 10cm sections each side. It's also useful to weight the lid down to compress the gasket onto the ceramic as it cures- I used a 7KG dumbbell suspended from the lid handle.The product has worked well and is still strong after a lot of heat and cooking.

Been using this for years now, brilliant stuff.Used this tube in the assembly of an outboard motor, (not the head gasket or exhaust) but pretty much all the other joints. Works very well. It does go hard in the tube after a year or so, but so do all silicon products. Next day delivery via prime is a real bonus when you realise your old tube has gone off 👍

dose the job

Good sealant. used on gearbox selector mechanism and no leaks after a couple of months, so does the job!Prompt delivery from seller, recommended.

I purchased this product after trying several other alternatives. I had a crack in the weld between my catalytic converter and the main exhaust pipe. I had it reweldeded a few times until the weld would not take any more. I couldn't afford at the time to buy a new cat for the exhaust system. So out of desperation I did some research and found this product. I took the welded joint apart and generously replaced it with the silicone making sure everything was sealed. The colour was awlful but hey who was going to look under the car but a mechanic. I left it for 24 hours.To my surprise the silicone had worked! This job got me through for 3 months until I got my Cat replaced. Truely recommended product. I would use it again not only for it's intended purpose but for any exhaust system leaks.

I bought this to see if it would bring my old Ryobi petrol strimmer back to life as the engine seals on it had long since perished. It worked perfectly!! Saved me a fortune as "original parts" are expensive. I stripped the motor down, cleaned it up and applied the Copper Sealant carefully and sparingly were needed. The strimmer has started first time, every time with no loss of compression through the seals.Even if I only get another summer out of the old thing, the Copper RTV Sealant would have been more than worth it.

I used this item in conjunction with a new exhaust system that I installed. I purchased this as the crush gaskets didn't look as though they would create a tight enough seal. No leaks after installation, which may have come down to the mixture of new gaskets and this item. I was expecting some sort of leak, but happy to report that the car started up, leak free.