Netatmo Rain Gauge for Weather Station, NRG01-WW, Accessory

This is the second rain gauge I have bought; the first was destroyed by a Tesco delivery van. The previous unit has worked well for a couple of years and is an excellent addition to my weather station. I am not sure of the absolute accuracy, but it is a reliable indicator if the rain is very heavy or light. Simple and robust construction - but I recommend installation away from rogue delivery vehicles.

I bought this along with the wind gauge and the weather station so it was a pretty expensive gamble that I liked it. As it turns out, this gauge is a great addition to the weather station ownership. It's easy to set up/calibrate, but, the battery compartment isn't that good. Given the attention to detail of the wind gauge and the outdoor module, this is harder to get into to add the batteries. The instructions tell you to twist the base and it'll come open. It doesn't do this easily at all. It could just be stiff due to being new, perhaps. This aside, I added the gauge to the system, calibrated it with 100ml of water, and then mounted it to a fence post with a cheap CCTV mount. This was all done in the space of about 10 mins (with a further 10 mins trying to get into the battery compartment!). Once it was setup and in place, I then went into the web admin page, into the settings panel, and deleted the recent rain count (from the calibration stage) and it was all good to go. It's been accurate so far and the radio signal seems pretty strong. The weather station isn't in-sight of the gauge, and a fair distance away, so it's pretty good. No idea on battery life yet, but it claims around a year which is pretty good for 2 AA batteries.

Excellent addition to my weather station. Finding a place to mount the gauge was the most difficult part! It needs to be clear of anything that may cause a 'rain-shadow', trees, houses, fences etc and within range of the base unit. In the end I installed a post in the middle of the garden that positions the gauge in clear space and above all planting. Seems to work a treat. Make sure you install the gauge absolutely level as the tipper mechanism relies on this. Basically the funnel takes the water to a tipping bucket switch in the centre of the unit, when the little bucket is full, it tips to the side and the second bucket fills up, empties and then repeats itself. I think each "tip" of the bucket indicates 0.3mm of rainfall.

Arrived in excellent time and in good condition.

Got a Netatmo weather station last year for xmas, excellent kit works well no problems. Added the Anenometer and Rain Guage this year, big mistake. The cosmetic quality and feel was very good, these are expensive items but neither "add on" worked. The rain guage just would not connect to the weather station no matter what I did so waste of time and money straight off there. The Anenometer connected to the base station and worked OK but constantly reported a flat battery (despite trying new batteries several times including the factory fitted ones) the sensor was not working. This means that the thing emails every half an hour demanding the battery is changed ASAP. So most of Xmas day was spent by me climbing ladders and faffing about with these items pointlessly, my wife didn't get her Xmas present, returning both to Amazon who "cannot replace them" and will refund the cash. Both of these items dead on arrival with critical faults looks suspicious to me, purporting to be quality "smart" devices the ones I got are bug ridden rubbish and wasted a lot of my time and patience. I won't be buying anything from this bunch of clowns again.

Small, functional but a little too light as it can be blown over by strong winds. I have mounted mine on a small foldable plastic tripod as I don't want to risk a full sized tripod out in the rain. It would be good if Netatmo sold a spike with a ¼" thread so that the gauge can be mounted at a reasonable height without fear of splashing causing bad readings. Over all this is a neat device and it can also be calibrated relatively easy although listening for the click when the internal buckets flip is somewhat difficult. It is easy to link to your Netatmo weather station system.

Drops the signal to the main Netatmo base quite frequently, despite being quite close to the outdoor unit and the anemometer, both of which generally maintain contact. Netatmo's help page seems to anticipate such problems. Disrupts readings and record taking. Not what I expect from an expensive piece of kit. Disappointed.

I wanted to expand my Netatmo Weather Station for Smartphones by adding a rain gauge, an important features lacking from the basic weather station kit. Like other products from Netatmo it arrived very well packaged and presented almost as an Apple product in a heavy duty and up market white box with elaborate packaging within but an annoying minimalist User Guide. As you would expect it of course is fully weather proof with the two supplied AAA batteries inserted into a waterproof housing within the unit. Installing the unit is easy enough and performed using the mobile phone app - be sure to follow the instructions carefully and in the right order. Don't remove the battery protection tape which powers the Rain Gauge until the instructions say or it may not register, as I discovered. The registration process needs to be performed close to the Netatmo Base Station but once this is done the Rain Gauge can be moved outside. I was surprised how strong the link is between the rain gauge, outside monitoring unit and the base station - this is indicated on your weather station control page accessed with your web browser - and despite the stone wells of my house I was able to set in the back garden about 15 yards from the Base Station. Mounting the unit can be a problem as it needs to be positioned level and in a location away from trees or anything that may keep the rain off. There is a standard tripod female screw mount on the base so a tripod could be used. In the event I used gaffa tape to secure mine to the top of a bird feeder pole making sure to keep the drain holes on the base of the Rain Gauge open. Another cheap option would be to use a selfie stick- many of which have a screw mount on the end - pushed into the earth with the Rain Gauge on top. The Rain Gauge is made of plastic and pretty lightweight so a sturdy mount is needed to keep it securely in place when the wind blows. My gauge has been running now for about two weeks with no issues and seems to be working well. There are other users of the Netatmo system nearby and I see their rainfall readings are similar to mine. This is a useful, if not essential, addition to the Netato system and once set up it works very well. The Good Easy to setup Attractive design Well packaged Functions well Low maintenance The Bad Expensive No mount supplied Poor documentation Lightweight so needs a secure mount

Brand new…….excellent.

Neben der Netatmo-Wetterstation , der Haupteinheit inklusive Aussensensor, habe ich als Grundausstattung noch den Netatmo-Regensensor und einen zusätzlichen Innensensor geordert. Der Regensensor besteht im Gegensatz zur Haupteinheit und den Innensensoren komplett aus Plastik. Das Material ist laut Herstellerspezifikation resistent gegen UV-Strahlung und Hagel. Gemessen wird der Regen mechanisch über eine sogenannte Niederschlagskippwaage, welche einen Messbereich von 0,2 mm/Stunde bis 150 mm/ Stunde aufweist (dies entspricht 0,2 Liter / Quadratmeter bis 150 Liter / Quadratmeter in einer Stunde). Inbetriebnahme Die Inbetriebnahme funktioniert wie bei der Hauptstation und bei den anderen Sensoren völlig problemlos und intuitiv. Voraussetzung ist natürlich der Account bei Netatmo und eine bereits installierte Haupteinheit. Bei der Inbetriebnahme müssen die bereits eingelegten Batterien aktiviert werden. Hierzu muss die Basis des Regensensors vom restlichen Teil entfernt werden. Nach dem Ziehen einer Lasche sind die Batterien dann korrekt eingelegt. Nebenbei sieht man bei dieser Handlung das 'Herzstück' des Sensors, die mechanische Kippwaage. Ist der eine Teil der Waage mit Wasser gefüllt, kippt die Waage ' löst den Messimpuls aus und entleert das Wasser nach unten aus dem Sensor heraus. Genauigkeit Ich habe die Kippwaage jetzt einige Tage mit leichtem Regen in Betrieb (nie mehr als 5 mm / Tag). Um die Genauigkeit einzuschätzen, hab ich mir gedacht, guck doch erstmal auf der Netatmo weathermap nach benachbarten Stationen und deren Messwerten, wenn Sie denn einen Regensensor installiert haben. Im Umkreis von 2 km gibt es drei weitere Netatmo Wetterstationen welche in der Aufsummierung der täglichen Regenmenge nie mehr als 0,3 mm / Tag Abweichung zu meiner Station hatten. Insofern schätze ich die Genauigkeit als relativ hoch ein und die Abweichung als gering. Netatmo selber nennt in den Spezifikationen sogar eine Messtoleranz von 1 mm / Stunde. Neben der Inbetriebnahme und der Anbringung habe ich am Regensensor nichts ein- / umgestellt oder nachkalibriert. Anbringung / Halter Ich habe den Regensensor an einem Nebengebäude im Garten mit einer Entfernung von ca. 3 m von einem Wohnhaus und in ca. 2m Höhe platziert. Da kein Halter mitgeliefert wurde habe ich hier auf eine Halterung gesetzt, welche es beim großen Auktionshaus für rund 7 Euro zu kaufen gibt. Zu finden ist der Artikel mit den folgenden Begriffen: "Kamera-Halterung Stativ Kamerahalterung Universal-Wand-Deckenhalterung Drehkopf" (Vielen Dank an dieser Stelle an den Rezensenten 'Alexander genannt Hotte' für den Hinweis in den Kommentaren seiner Rezension). Die Halterung ist alle Richtungen korrigierbar, so dass eine Anbringung des Sensors mit Wasserwaage möglich ist. Personifizierte Meldungen Wie bei den anderen Sensoren können personifizierte Meldungen aufs Smartphone eingestellt werden. Die Übertragung von gemessenen Werten wird allerdings in Abständen von mehreren Minuten zur Haupteinheit übertragen bzw. von der Haupteinheit abgefragt. Somit ist eine sofortige Meldung nach den ersten Tropfen auf das Smartphone so nicht möglich (Stichwort: bei Regenbeginn schnell die Wäsche abnehmen). Zumal auch erst eine kritische Mengen an Regen erreicht werden muss, bis einzelne Tropfen im Trichter sich zu größeren vereinigen und den Trichter herunterlaufen und den Messimpuls auslösen können. Regenmesser im Winter? Natürlich stellt sich die Frage: was passiert mit der Kippmechanik bei Regen und anschließend schnell fallenden Temperaturen (Blitzeis bzw. Eisregen), Schnee oder starkem Frost. Kann die Kippmechanik hier im Frostzustand kaputt gehen? Für den nicht unerheblichen Preis hätte der Hersteller hier eindeutigere Hinweise auch in den Produktspezifikationen geben können. Im Zusammenhang von Kommentaren des Herstellers auf Kundenfragen bzw. in Rezensionen liest man davon, dass der Sensor bis Temperaturen von Minus 20 Grad im Freien verbleiben kann. Fazit Ich bin zufrieden und habe die Anschaffung nicht bereut. Eine sinnvolle Ergänzung zur vorhandenen Netatmo-Wetterstation. Der Sensor lässt sich leicht in das vorhandene System einbinden. Über das System der Cloudspeicherung sind die Werte von mobilen Geräten abrufbar. Personifizierte Meldungen an mobile Geräte sind möglich. Der Sensor misst nach meiner Ansicht sehr genau. Etwas ausführlichere Informationen des Herstellers zum Sensor wären zu wünschen.

Smidig installation och fungerar jättebra

Ho acquistato il Netatmo NRG01-WW Pluviometro per completare la mia stazione meteo Netatmo, e devo dire che è un accessorio essenziale per chi vuole monitorare con precisione le precipitazioni. Dopo diverse settimane di utilizzo, posso confermare che è un dispositivo affidabile, accurato e facile da integrare con il sistema Netatmo. ✅ Punti positivi: ✔ Misurazioni precise e in tempo reale: il pluviometro rileva con estrema precisione la quantità di pioggia caduta, fornendo dati dettagliati sia sul momento che in forma di storico. È perfetto per capire l’andamento delle precipitazioni nella mia zona. ✔ Facile installazione: il montaggio è semplicissimo. Ho posizionato il pluviometro in un’area aperta, lontano da ostacoli, e l’ho collegato in pochi minuti alla mia stazione meteo Netatmo tramite l’app. ✔ Dati sempre accessibili: grazie all’app Netatmo, posso controllare le precipitazioni ovunque mi trovi, ricevendo notifiche in caso di pioggia e analizzando i dati storici per avere una visione più chiara delle tendenze meteo. ✔ Integrazione perfetta con la domotica: l’ho collegato al mio hub Homey Pro, permettendomi di automatizzare alcune funzioni, come chiudere le tende da sole o spegnere l’irrigazione quando inizia a piovere. ✔ Qualità costruttiva eccellente: il dispositivo è solido e progettato per resistere agli agenti atmosferici, garantendo prestazioni affidabili nel tempo. 🔎 Conclusione: Se possiedi una stazione meteo Netatmo, il pluviometro NRG01-WW è un accessorio che vale assolutamente l’investimento. Preciso, facile da installare e perfettamente integrabile con la domotica, è ideale per chi vuole monitorare con accuratezza le precipitazioni e migliorare la gestione di giardini, coltivazioni o semplicemente rimanere sempre aggiornato sulle condizioni meteo locali. Consigliatissimo! Se possiedi una stazione meteo Netatmo, il pluviometro NRG01-WW è un’aggiunta essenziale per monitorare con precisione le precipitazioni e ottimizzare la gestione di giardini, orti o semplicemente per avere un quadro chiaro del meteo locale. Facile da installare, preciso e altamente integrabile con la domotica, è un prodotto che consiglio senza esitazioni! ✅ Facile installazione ✅ Misurazioni precise e in tempo reale ✅ Storico dei dati consultabile via app ✅ Perfetta integrazione con Homey Pro e altri sistemi smart ✅ Resistente alle intemperie e con ottima autonomia Se vuoi migliorare la tua stazione meteo smart, questo pluviometro è un acquisto da non perdere!

Super rien a dire