Slime 20272 Bike Skabs Pre-Glued Patch Kit, for Bike Tube Puncture Repair, Peel and Stick, Contains 6 Patches and a Metal scuffer

These are really cool there thick enough to hold well and sticky I'm a fan... for touring or mtb no waiting for glue to dry makes a flat so much more bearable

It works really good, and easy to use.

It took two of these just to limp 3 miles home at half pressure. They don't adhere to the tube very well and can't seem to hold the pressures necessary for a road bike tire. While they're super easy to apply (no rubber cement needed!) that's also their downside. I have spare tubes I patched years ago using a traditional kit that are still holding up, while these can't seem to stick for more than a few minutes.Buy these if you like practicing tire removal + replacement, otherwise get a regular patch kit with rubber glue.

I have used these patches before, so I know they work well. Many have reported they do not stick well to the tube. I will tell you all the trick. Keep with you some rubbing alcohol pads in your tool kit. Clean the area before you ruff it up with the scratch pad and then clean it again after scuffing the tube. Allow it to dry fully then attach the patch. I have been doing it that way for many years using these pads and never had a failure. I hope that helps you all. This is why I buy three packs at a time, because I know they work!

Realmente no los puedo engañar con ningún comentario positivo o negativo los compré para un regalo pero aún no los han usado aparentemente a simple vista parecen buenos y los recomendaría para un momento de apuro

Very easy to use. The self adhesive is very strong.

Not sure If these can't take high air pressure over 90psi or they just don't work very well. I ordered them while waiting to get a replacement innertube for my wheelchair as I could get them the next day before my innertubes arrived. They are easy to prep and attach to an innertube and my innertube is the same as a roadbike 24"x1" bicycle tire. I tried 3 out of the kit and all 3 failed to seal the hole so I quit messing with them. I'm not sure if they can't handle 90+ psi (they should) or what , but they didn't work for me unfortunately. They held air for maybe 3 minutes max after airing up the tire and then deflated. 2nd attempt I slowly added air up to 90 to maybe let them stretch and adhere and 3rd attempt I massaged the patch all around to make sure it was firmly attached. Maybe on tubes that use less psi or are wider , they may work. I was unable to find any info on the psi they can handle so If you have a bike that takes 90+psi or more , I would be a little hesitant. If they worked , they would be great for quick temporary repairs. In my case , they were a waste of time and money.

Awesome easy to put on, not too thick. The size is great.