Stove Fire Rope 10mm x 3m Length & Reeds Glue 50ml Kit Woodburner Log Burner Door Seal Kit

Good product, could do with additional tape for the ends depending on the type of door (if rope has to be fitted in two pieces) Seems to do the job it was designed for.

So easy to use! Prep is important - remove the old rope and have a good clean of the rope-runs (to remove old glue, rope, rusty bits and ash). Then, fit the rope to gauge size and cut accordingly (using the included tape to seal the rope ends), then get to sticking! The glue isn’t runny at all, it’s very thick (needing a good squeeze to get out of the tube) and goes in to the rope-runs easily. Once the glues in, press the rope in place. I glued the rope at the top of the door as a start, then down the sides, then across the bottom, and the middle last (as this couldn’t be clamped). YOU DO NOT NEED TO REMOVE THE DOOR! I fitted the new rope with the door in place and used washing pegs to clamp in place while setting (it’s advised not to close the burner door for at least an hour after gluing new rope). So very easy to do. Great product.

Generally OK but glue bottle split, which made it a bit messy. Seals seem to work well.

Great, simple to install, sorted leak in stove, would be great to get more adhesive to rope ratio. Otherwise delighted to sort issues, simply and cost effectively.

Cut to length on my stove and clued in and still fine after over 6 months use

Good product

Item arrived quickly and is as described. Some points to bear in mind: 1. No instructions included. With some potentially nasty adhesive to use, some instructions would be beneficial. 2. The strip of adhesive tape is very fiddly to get the back off; took me about 20 mins! 3. Don't squeeze the adhesive container too hard as the top may come off depositing a large dollop of glue where you may not want it........ Apart from the above, seems to work okay.

good buy