Door Viewer Peephole,Solid Brass 200 Degree Peep Hole with 16 MM Drill Bit for 1-1/2" to 2-3/8" Doors,5/8 Inch Pipe Diameter Door Eye Viewer with Privacy Cover (Mirror Polished Chrome)

The peep hole is built well and easy to screw into place with no unforeseen issues, which is nice for once.The hole saw that came with it was surprisingly nice quality!!! It was thick, sturdy, and went through my steel door with fiber core like a hot knife through butter!!I feel like I could drill tons of doors with this hole saw without issue, it is not flimsy or thin in any way.Now the instructions are underwhelming. They simply state something like "drill with bit on both side of the door separately" versus trying to go through the whole door... which is likely not possible with the short length of the bit and saw.I have never installed one so I started with a long drill bit to drill a pilot hole all the way through the door.... this was not a great approach because apparently I was good with up/down tilt but not on left/right tilt.I then drilled the holes on both side of the door with the whole saw and discovered my 2 seperate holes were NOT in alignment to allow the peep hole to be flush from both ends when installed.*****IMPORTANT - I then had to enlarge the hole on the OUTSIDE of the door. The outside exposed portion of the peep hole has a larger surface area so it can cover more hole enlargements and mess ups than the interior side of the door and peephole will allow. So fix from the outside, not from the inside!I was fortunate that I could make the whole big enough yet still able to be covered by the peep hole and no one will ever know unless they pull it off, phew.To do it all over again the fool proof method would be to simply measure from left right of the door and make a mark in the center. Then measure from bottom of the door up to the dot and write down that height value.Go to the outside of the door and figure out how high up to go and then do the left right center again and put another dot. Drill a pilot hole on each dot.Now use the hole saw to drill the holes from each side. At this point, the risk of being off from both sides is eliminated or so minor that fixes won't be an issue

Great product at a great price. Installed today.

Looks good just wish my contractor put it lower on door as I have to go my tip toes to use. Like the cover.

Very easy to install. The only complaint I have is that the part you look into is not clear. I think it’s plexiglass. I wish I had gotten a glass one. I can live with this, just wish it was clearer.

Works perfect and looks great in my door

Took me about 10 at most to install. Drill small pilot hole so it barely punctures to the front. Then use provided drill bit to drill halfway through each side. Then screw in peep hole to each side. Beautiful fit.

The HOJLKLD peephole does what it should, however the wide-angle is the same as the $1.79 peephole I replaced and the image is somewhat blurred. Additionally the drill cutting tool that was supplied very quickly loaded up with wood from the door and it took nearly 20 minutes to complete the task with repeated stops to dig out the wood from the clogged cutting tool.This is an okay peephole, but the blurriness was the worst disappointment.

That this product is a good quality .