Rain& Light Sensor Gel Adhesive FILM Silicone Cushion Pad Windscreen Chip Repair Kit Multi-Purpose Tape for Car

I installed in my car after windshield replaced and fixed automatic wipers problem little tricky to cut

EXCELLENT PRODUCT compatible with the rain sensor of the 2011 Chevrolet Captiva Sport 3.0 V6. With this pad, my vehicle's sensor is working like new. I had difficulty removing the red tape from the pad and contacted the supplier. Below are the instructions I received from the supplier, and then everything was easy and fine. 1) Cut the pad to the required size according to your sensor; 2) Remove the white tape and adhere that side of the pad to the sensor bracket; 3) With the pad now adhered to the bracket, remove the red tape. To remove the red tape, you should use this method: Use a hair dryer on a medium heat setting to evenly heat the red tape. Keep the dryer 6-8 inches away from the tape, moving it back and forth to prevent localized overheating. Heat for about 1-2 minutes. After heating, gently lift one corner or edge of the tape using your fingernail or a plastic scraper. If you still feel significant resistance, do not force it. Return to step one and continue heating until the tape can be lifted. Once the red tape is removed, adhere that side of the sensor bracket to the windshield. Critical steps: a) Install at ambient temp, don't warm the gel. b) Clean the windshield with lint-free cloth + rubbing alcohol/glass cleaner (remove dust/oil). c) Press the bracket firmly against the windshield for 30–60 seconds to squeeze out air. d) Let cure 2–4 hours (or overnight) without moving/adding weight. e) install the sensor in the bracket

Merci beaucoup

Have you ever bought a used car only to find that the intermittent wipers didn't work? Well, I did. Thought i was going to have to replace switches in the column, or worse yet, replace the rain sensor. This fixed my issue, and i only needed half of a pad. Like others have said, peeling it can be a bear. But it works, and works exactly as it should.

Installed for my Land Rover sensor. Works perfect as the membrane. Careful though to not get it dirty before you install it.