🔥 Upgrade your 3D printing precision with plug-and-play power!
This 4-pack of high-precision NTC 3950 100K Ohm thermistor sensors is designed for Creality Ender 3 series and compatible models. Featuring fast heat conduction, high temperature resistance up to 300°C, and easy installation with a standardized 2-pin connector, these sensors ensure reliable temperature monitoring for superior 3D printing results.
P**N
Perfect Replacement!
The product was a perfect fit for my Ender 3V2 and cable length did not fell short either. High quality and works as intended without mentioning easy installation.
A**R
Works great for Ender 3 V2
This is the only brand I found that worked with the Ender 3 V2.Many other companies sell a thermistor that say they work with Ender 3 V2 but their cable is only 1 meter long. This product is 1.2m long and while it's about 2" shorter than the factory cable it works fine because there is a little extra in the control box from the factory. Remember to use a razor blade to cut the hot glue the factory installs on the existing cable to keep it in the terminal during shipping before trying to remove the factory cable.
D**K
Just the Right part
Needed this for a customer Repair. Easy install and his Ender 3 was back up and ready to roll!!!
R**D
Great!
Work as intended and with spare parts, great!
J**N
Direct replacement
These thermistors are direct replacements for any Honeywell/NTC thermistors and have the JST micro connector.
X**O
DEFECTIVE
Don't work.... Installed in printer and says extruder too HOT!.. they don't work.
M**H
Do not tighten the set screw beyond just touching.
With a little conductivity grease these work perfectly. I must have over tightened the first one, the second worked great.
Trustpilot
1 week ago
1 day ago
