DC62-00214M DC62-30314K Washer Cold&Hot Water Inlet Solenoid Valve Set Package for Samsung, Maytag, Replace AP5623062, 2979589, PS4208704, DC62-30314H, 1810145, AP4204535

Product works great. Thx!

Works Great exactly as original and even better. easy to install . no setup required.

GOOD QUALITY AT A GREAT PRICE!

The threads on the valve are wrong and do not allow you to screw the hoses onto the valve. Not made for standard American washing machine hoses.

Worked exactly as intended, perfect fit. Replaced a pre-wash solenoid valve that wasn't closing fully/consistently so washer kept throwing "0e" overfill error, and drain pump had to run constantly. Appeared to be an identical product to the original Samsung part, although I think the plastic manifold is very slightly different - see threading note below. You have to replace all 4 cold water valves as an assembly, because they are integrated into the cold water manifold. Samsung and most aftermarket suppliers would only sell the entire tray and valve assembly, $250+. This was a tenth the cost and a 1 hour job including the time spent figuring out the hidden test mode to verify each valve worked. Comes with hot water valve too and I replaced that as well because... it was there? New > old? No leaks, fittings threaded on fine, although the starting threads aren't tapered as oem so getting the supply hoses initially lined up to spin on took an extra moment of care - don't force it. Make sure you have fresh seals on the hose fittings, and use pliers to give it an extra 1/8th turn past hand tight. The only concern I'll express is that there seems to be a more pronounced water hammer when the diaphragms close. Stronger springs than oem? The price plus speedy delivery make it an exceptional value. Have run roughly 40 loads at this point, no issues. I dropped a star because of the water hammer - YMMV. It seems our plumbing is not secured tightly where it runs through the open truss structure - I can stand directly under two points and hear the pipes bang. Will have to get up into the attic to add some stand-offs.

Nice set. went into washer spare parts drawer.

Loved it fixed my issue, e was easy to install

Both fit great, and a reasonable price!!!

I would have given a 5 star review, and wanted to give a lower star than 4 stars but part of the issues were caused my me. Firstly you should check what threads are on the back of your washing machine before you take things apart. Our washer has garden hose threads going into it. The replacement solenoid valve has pipe threads which is finer. I had the valves installed and was threaded the hoses on to the hot and cold side not realizing my error with the miss-matched threads. So I had to purchase two adapters from male pipe thread to garden hose thread as shown in the picture. That was a bit of an annoyance, but the larger one was now I had to try repair the little bit of cross threading that I caused on both inlets on plastic threads! For this I had to pull both valves out and try file the plastic back to some semblance of a pipe thread. By now I am swearing like a sailor at both myself, the washing machine and the supplier. I get the threads all fixed up. I reinstall the valves and attach interior hoses and supply hoses with the adapters (with Teflon tape, otherwise they drip) and pop the top back on the washer (wait before doing this step) I then load it up and hit start. All good until water starts running everywhere!! I hit the pause button and shut everything down and once again pop the top off the washing machine. Again it’s an Ugg moment as I missed one hose clamp! But asides from that, everything went smooth. Don’t forget to double check things or your quick job will be a lot longer.

Doesn’t fit standard washing machine hoses. Thanks for nothing.