10 Pcs Black Fader Knobs Mixer Slider Caps for Pioneer

Very fast delivery, very happy with the graphic slider knobs for my amplifier.

They do the job, but are not an exact match to the originals and feel a little lightweight / less robust. They are not bad for the price though.

Did not fit my djm500. The caps don’t clip on and are loose. They don’t sit above the faceplate of the mixer either. So they will take the white markings off if you use them.

need 4 of these for my XDJ-XZ which is 6 years old the Genuine replacement are £24 each that would have set me back £100... i wasn't expecting much but I thought I would give it a try... ... turns out they fit perfect and feel good the width is a little shorter that the original ... but I works for me so nearly 10 months later and allllllll good

Size listed is accurate. I used these to replace slider knobs on an old Realistic equalizer. The fit on the post was terrific, the post is a step down type so the recessed hole worked as it should. Nice tight press fit. The only issue I have is the width once on the equalizer. The knobs just contact ever so slightly, only in the grouped band frequency, but don't prevent function, you can just barely feel the contact but is slight enough not to move the adjacent slider. This was the best fit I could find and the appearance satisfied me for original apperance. I was missing one knob and I wasn't going to spend $12 for a replacement single. I've included a pic with the original width knob. So tough to tell what will fit online, even with accurate dimensions. I'd buy these again. Hope this helps someone.

These worked very well on my vintage mixer. Felt and looked like it was the original.

Sehr gut passen gut auf das Bell Pult.

Bought these to replace a couple missing and heavily scratched sliders on a used Numark Mixtrack Pro II that I bought, I wasn't really a fan of the original silver/grey ones anyway. These fit perfectly and worked well. A couple of them fit a bit too close to the board, but a few minutes of light sanding on the bottoms to shorten them slightly did the trick!

Good for price!