Tnisesm 12Pcs 3 Pin Screw Terminal Block Connector 5.08mm Pitch Pluggable with 3 Pin Phoenix Plug 300V 15A for 28-12AWG Cable

These are a standard type of connector for power on some devices. The quality of the connectors I received is excellent. The screw terminals on these connectors are sturdy enough to make solid mechanical connections to wires or even pins. The size of these makes them useful for power or high current signals. They are keyed and lock together so that a decent amount of force is needed to disconnect them. There are 12 pairs of male and female connectors. All the connectors have screw terminals, and are not made for soldering onto a board. You might get away with screwing two adjacent terminals onto two pins of a board, but not all three. I was able to take a barrel power connector with screw terminals and use two pins to connect with these. They work better with wires, and I finally used a barrel connector with a soldered wire pigtail.

The connectors worked great!!!!! I would buy again. I took one star off because the small screwdriver handle broke the second time I used it to tighten wires to connector. I would buy a better small screwdriver.

Works for my projects

Nice quality,

These are great. It’s kind of hard to find female Phoenix jacks. Males abound, but you get both here. I made Phoenix to XLR jumpers for when I needed to swap older equipment in for newer equipment that’s failing. Where the Phoenix plug plugged into the newer piece, I plugged that into the female Phoenix to XLR jumper and went straight into the older equipment. Quick and dirty. I just ordered my second set.

These are your typical 3 pin screw terminal block connectors that utilize a 5.08mm pitch. The rating is for up to 300VAC and 15Amps which is far more than I need. I use these with my Arduino projects and therefore never exceed 12V and 5 amps. So they are perfect for my needs. They snap together tightly and the terminal screws hold well. They are of good quality.

These are great inline terminals. I use them to make it easier to disassembled the accessories on my laser cutter. They tighten down well and they come apart with _just the right_ amount of force.