FLOLAB NanoArmour ONETIME PRO for iPhone 15 Plus Screen Protector, Anti-Reflective, Anti-Rainbow, 3D Tempered Glass, Ultra Clear, Edge Reinforced, Easy Install, Dust-Free, Scratch Resistant

This is an initial review on the installation and first impressions of this screen protector. As of typing I have only had it on for about 24 hours so will refrain from commenting on durability.I picked this case after reading several reviews on screen protectors for my iPhone 15 Pro Max. I usually refrain from using screen protectors for three main reasons: the first being I can always tell that a screen protector is on due to sizing of the glass. It alway seems that the screen protectors have a noticeable edge to them that doesn’t run to the edges of the phone. I understand this is often times with case compatibility but this seam always attracts hair, dust and other particles that get caught in the edges. The second issue that comes due to the first is that because of these edges, chips and cracks are much easier to occur. This of course makes me want to remove the screen protector and install another. The final reason is instillation. I have used a lot of different screen protectors for various phones over the years and no matter how good the kit, instructors, and my pressing is, I still seem to end up with bubbles that I can no get rid of which ruins the whole experience for me.Enter FloLab. The instillation guide is very easy to follow and the items included also have step by step instructions so you can follow along both ways. When I reached the final step of removing the instigation bracket, I was unsure if the screen protector applied or was still in the brackets. That’s how easy the install was and how seamless the glass is. Had I not seen one small bubble on the edge of my screen (which I removed with the applied squeegee) I would have continued to think there was no screen protector on. The edges of the glass have a curved finish to them providing a smooth transition from the screen protector to the phone itself, adding to that feeling of not having a protector on. I currently have a Spigen MagSafe case on my 15 Pro Max and when running my nail between the screen and case I cannot discern where the glass is. I would compare this feeling to using Samsung Galaxy or other curved screen phone without a protector on. I think this will increase the overall durability of the glass with no sharp edges to chip or crack but that remains to be seen. My final issue is the claim of the anti-glare coating. This was not the reason I bought the screen protector but is a clear main marketing point for this version. I haven’t been able to notice a significant reduction in glare on my screen which is a shame. Overall, I think the pros of this screen protector heavily outweigh the cons. It is not the most expensive screen protector out there but it certainly is on the premium end when it comes to price. However, I think the perceived longevity of this product, combined with its quality and easy instillation make this a must pick for any iPhone user

It is easy to install and looked good for about two and a half weeks. I suddenly noticed two cracks (see photo) and wasn't even aware I had done anything to damage it. The top red semi-circle shows obvious damage. The bottom one is difficult to see in the photo. If you look carefully at the bottom half inch you will see a hairline crack. If you were holding the phone, you would see that the crack parallels the red semi-circle all the way to the top. When I removed the screen cover, I could easily bend the glass inside the red semi-circle.I returned the cover to Amazon rather than asking for a replacement from FloLab for two reasons: (1) FloLab doesn't make it easy to ask for a replacement on their website and (2) I figured if it broke once so easily, the replacement probably would break, and I wouldn't be able to get a second replacement, nor would I want to have the hassle.Good luck. Your mileage may vary.

I would like to give this screen protector a 4 or 5 star rating because it is great. However, there were and still are some issues with it for me. First off, although the installation is simple enough and all the provided installation parts are great, I had an issue while installing it. I followed the instructions to the “t”, but when I pulled on the tab (slowly as stated in the instructions) to remove the film covering the sticky part that is supposed to attached to the screen, the tab came out and the film covering the screen did not. So I had to remove the screen protector and the installation jig, remove the film covering the screen protectors, made sure that the screen was lint free, installed the phone into the installation jig that was still holding the screen protector and I was able to install it. Everything looks great and looks like it is lined up. However, as soon as I installed my case the bottom right edge of the screen protector lifted up. I pushed down on it and tried to get my case to sit on top of it and it seemed to work. Fast forward a few hours later and that same corner is lifting up. I push it down and readjust the case and I comes back up at some time during the day. So… what do I do? Do have to replace my case? I paid about $40 for one screen protector and there was not indication that it might not work with my case, which by the way is just a simple clear case nothing fancy. Anyways, if it stays down it is a great screen protector. Maybe I’ll reach out to the manufacturer and see what they say.Update: I contacted the manufacturer Flolab and they were very responsive and agreed to replace my screen protector. I had to pay for shipping ($9.95) but that is part of their warranty program. I increase the rating to 5 as their customer service is superb and the product is as well (as long as the installation kit works as it should). If you are wondering, no, they did not ask me to leave a good review.

the screen protector and installation process was great! anti-glare is as good as the day i installed it, (about 5 months ago), however, the anti-smudge coating/water resistance has worn out just a little bit over time, but nothing a good alcohol wipe won’t fix. overall, the best screen protector i’ve ever had, it’s worth it. i’ll probably buy one soon just so i can clean my phone, it also works with most cases, at least the ones i’ve used.