Viva Sanitary PP0021 Cistern To WC Pan Bolt Through Kit - Stainless Steel

I always use these even on new cisterns, far far better quality, and leak proof and never rust or deteriate.

Great length some nice nuts with them and rubber fixings look lovely and seals the cistern with great elegance just fit as per instructions on back of packet ensure you fit properly test for leaks before fitting permanent to bowl.Mines fitted great and review for me is nothing but positive you can't get it wrong you fit the rubber over the bolt and push it right the way down to the shank of the bolt head then the metal washer with the lovely nut screwed easily all the way down the shank of the bolt to the washer tighten slowly until feels tight then do the other bolt go onto check water doesnt leak by adding some water into cistern if no leak u got it right and pat yourself on the back.Now put doughnut not supplied onto the toilet place out pipe of cistern onto the base on top of doughnut and direct the bolts slowly into the holes on the toilet ensure you don't let go of the sisters else u might bend the bolts or break toilet.Hold plastic washer on the bolt then push metal washer then finish off with fitting your nuts and these nuts have wings just like red bull watch they don't fly away as you'll need them lol.Tighten up tight ensure your cistern doesn't rock if it does tighten wing nuts.When tight the bolts are done and your job is complete!I had no issues I fitted them easily to my cistern.No bad just good.Buy buy buy..... proper review..

It did the job

Good quality stainless steel parts with four conical rubber seals. This kit looks set to last a very long time and gives confidence that leaks will not be a problem.

Have got these a spares in readiness for any leaks. Looks like the parts are good quality and should do the job. It could be a bit of a pain to have to remove the cistern completely to fit these bolts but then again what part of plumbing is not a pain ?

The cone shape rubber washers make a good seal on the china pot. The stainless steel means no rust. Ideal for kit for close fit toilet.

Purchased to replace the flimsy plastic/nylon bolts and "finger" nuts supplied with a new cistern.Far stronger and better quality. In spite of that be careful not to overtighten and crack/break the ceramic. That will spoil your day!This is a branded product and according to their website technical data these are stainless steel, lets hope so.It's only a pair of long steel screw, conical rubber seals, wing nuts, hex. nuts and some washers and nothing to get excited about, but the kit does work very well.

After trying Wickes and B&Q which both sell a universal fitting kit which were both annoyingly short bolts and therefore did not fit my toilet, this kit was the perfect size with a bolt length of 100mm approx. The conical washers are a very tight fit and therefore sealed perfectly. I now have them installed and no more leaks. These bolts were the exact size of the original ones. Much better than I could buy at the DIY stores.