DEWHEL 8-Pin 81980-50030 066500-4650 Electronic LED Flasher Assy Relay Fix For Lexus Scion or Toyota LED Turn Signal Light Bulbs

Works well in 2011 Sienna limited, no more hyper flashing. Installed led switchback bulbs in the front and led turn signal bulbs in the rear.

Worked for my 2009 Lexus es350 :)

Fits on 2006 Toyota Camry, works with all led turn signals and also flashes when lock and unlock button is pressed like Toyota intended. Installation was super easy.

My Second Review on 07/31/23. Recently I wrote a favorable review on this item, however I must reverse anything good I stated. On July 30, 2023 I noticed while setting my alarm, my driver side light that usually flashes twice with the right side while setting the alarm flashed very weakly, and almost unnoticeable. This caught my attention immediately, so I decided to check it out just a little bit more. I turned on my hazard lights, and I noticed the same light bulb would blink three times and then flash almost unnoticeably, three or four times, before it flashed again, 2 to 3 times. The passenger side worked perfectly. I immediately suspected the relay, since it was a malfunctioning of the system, rather than a faulty bulb. I went to another vendor on Amazon, and purchased the same kind of relay, I installed it, and everything works perfectly. The problem I have is that this relay that I purchased is already failing a very short time after I purchased it, all it does is control the hazard lights and blinkers and it illuminates the hyper flash that takes place with an analog relay and LED lights. Needless to say, I was very pleased with its function until it malfunctioned. Unfortunately, Toyota places the relay in an almost impossible location under the dashboard and it is extremely difficult to replace! However, I did manage to get it out and I plugged it back in to make sure it was secure and the problem persisted. That’s when I bought a new relay, it was delivered by Amazon the very next day. Upon receipt I went through the painstaking process of getting the old one out and putting the new one in and everything works perfectly. I’m not satisfied with theirs seller, and believe I should be refunded for the cost of their relay….

I prefer oem clicky sound, but who's complaining? It solve led hyper flash issue. Hope it won't blow any fuses like the forums say.

I have a 2010 Toyota Camry and recently switch all my front lighting to a led. after replacing the turn signal bulbs, I notice the hyper flash witch at first didn't bother me at all... but after some time it was annoying as hell. That's when I started my research for possible fixes, found the load resistors option but that implied way more effort, way more time consumption, a lot of money and making more modifications to my car, keep messing with the wire harness & electrical system of my vehicle. That was until I found this relay and was sold since the beginning, installation took me less than 1 hour and my turn signal bulbs came back to a normal speed! now I even replaced the rear turn signal bulbs and works great! Totally recomended!

Work perfect Toyota Sienna 2011 , I have headlight and taillights led , no hyperflashing

May 16, 2023 UPDATE:: 5 stars to 1. It quit working correctly. Passenger side blinkers would sometime come on, cabin indicator still click normal as if it is working but the outside, it doesnt light up. Driver side is ok. Led bulbs swapped, same problem. Remove module and put back factory flasher, bulbs are good. Even though it hyperflash now. So, this flasher is no good. Too bad it didn’t last very long. You need this if you change from halogen to leds for your turns signal. Simple and will fix the hyperflashing issue. Same size as factory. Only modification need is to trim the two side pegs down flush or completely remove from relay. Once you do that. It will plug into factory location and voila! Good to go. No need to add resistors to your turn signal wirings. The resistors gets VERY Hot. Ask my how i know.