Fender Flare Seal Gasket & Edge Trim - Rubber Seal for Car & Truck Wheel Wells, Bonds with Automotive-Grade Adhesive Tape, T-Style, 18' Length

If you are adding plastic fender flares to your car or truck these are a must. A bit tedious to attach to fenders, but well worth it. Take your time and do it right.

Worked great, easy install.

18ft no alcanzan para los 4 fender ni en broma. Recomiendo mínimo comprar 30ft. Parecen de muy buena calidad

They look good, but they’re a little thicker than the OEM Toyota ones. Still a very good product.

You need this for your Fender trim

I see some reviews stating that the adhesive isn’t good or it sticks to itself and hard to peel of if it gets stuck to itself or it’s not self explanatory. There’s enough for all 4 fenders and there will be extra for 2 fenders just in case. 1) just make sure the surface of adhesion is clean and dry 2) as you are attaching the beginning, go slow, put pressure so it sticks well, don’t try to stretch it to save extra because at the end you’ll have places where it’ll come right off, as you move along you will slowly peel of the adhesion sticker. 3) after installation if there’s small wavey areas just run your finger through the whole strip and it will flatten itself out and then cut off the excess. 4) you gotta let it settle overnight and not let it get wet for maximum adhesion.

Make the 3m tape wider and stick on top of the fender flare instead of under the lip. And why can't you make the tape wider under the lip of the flare? This didn't stick at all to my fender flare because it had ridges where the tape on your product was supposed to be so I had to redo them twice, the second time worked well by filling the ridges with contact cement and then reappling your seal

This is easy to install, peel and stick, and you can measure to length and cut what you need. Works really nicely at sealing off my fender flares and protection of my doors. ALOT cheaper than buying 15 feet for Orielly and Autozone

Love that it has double sided tape to make it super easy to apply, makes the finished product look professional

Quality is average, i dont think it will last long

Bon produit mais dommage la quantité livrée ne correspond pas à la quantité commandée ,commander 9 m livret 3 m

They did work on our fender flares but it was tricky to keep them in place during the install. Especially around any curves, the sharper the curve the harder it was. You need to clip the back with sissors just like if you are sewing material around a curve.

Great product used to replace seal on fender flares that come off