Adax Neo Wall Mounted Electric Panel Heater With Timer, Thermostat. Modern, With Temperature Display. Convector Radiator. LOT 20 / ErP Compliant, Made In Europe, 600W, White

Makes the world of difference to a very cold room ...we have a back bedroom and one end is always cold not wanting to take up the floor to fit another radiator we popped this electric one up and we are so pleased with the quality of it's performance it's very compact and very easy to use... I watch my smart meter and feel it's very good on the amount of electricity it uses....Would recommend ...

oK but expensive. Bangs a bit when heating up and cooling, the only ones I@ve found that don't do that are the glass-fronted ones, keeps them stiff and stable. We have a lot of convectors and the best ones are the cheapest, the fine wire convectors, heat up instantly and give a blast of heat, but sadly go noisy after a couple of years.

These are excellent wall heaters - we’re delighted with them! We have a slim one under the window plus a larger one on the other side of the room in both the kitchen and lounge, and one on the landing upstairs - together they are ample for all our heating needs - they warm the house really quickly. Best of all, they blend beautifully with our white walls and look great, which is a rarity when it comes to radiators and heaters! They were easy to install and operate, and seem really robust and easy to clean. Really, really pleased - thank you!

A lot more expensive than other products on the market but good quality is never cheap. Looks very stylish and works very well

This is a smart and unobtrusive radiator which works quickly and well. I am yet to understand the instructions to set the time so it is not working as I am sure it should .However, I am very happy with it.

Second one of these I've had, first one worked perfectly for 12 years which I think is fair, so bought identical replacement, hopefully we'll get the same length of service from it. Build quality is fine for the price. Fit it, set it and forget it...

When it came to installing the product and upon opening the box I noticed that the control buttons to the side of the heater had been pushed in beyond its normal position. A response should be to return the product as faulty. Being a qualified engineer, I decided to have a look myself, which in effect invalidates any warranty. Four tiny screws held the thin pressed steel casing together exposing nothing more than an electric heating element, a high-temperature thermostat, and a small PCB where the control buttons are located. The PCB had nothing to keep it in place apart from a thin slot for sliding it into its correct position. Any tab to hold it there didn't exist so it slid out. A ribbon cable was all that was stopping the PCB from falling out during transportation. The plastic control buttons were held with small plastic retaining clips of which there were none to the area which had been pushed back too far. I can only assume that this had been broken prior to the product being sent to me i.e. Already returned faulty and then sent out again.I would guesstimate that the complete product is manufactured for a cost of around £40 - £50 maximum. The manufacturer is obviously making a very high profit on this product of around 200% based on the amount that we paid....... enough said.

Looks Neat and Slim when put up..The heat output is very suffient for our 4m x 5m Conservatory.Exactly what we were looking for and very Easy to install...dont forget yo keep the box as it acts as a template for your screw holes....very pleased with our choice.