The sensor on models in & after 2012 can be read, only with some specified diagnostic tools. Before monitoring system works normally properly, the body control module will record ID information of each position in the sensor; and use the following methods to read the sensor after replacing a or wheel speed sensor. Please refer to the specific methods as follows: Step 1 - Enter leaning mode Set the gearshift lever to "P" Put the ignition switch to “ON†Enter the interface of display by DIC DIC shows "Press Set / Ctrl to re-learn" Press “Set / Ctrl†The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode Step 2 - Read sensor information Start from the front-left wheel, Make the J-46079 or Diagnostic Tool EL-50448 antenna up against the valve core position & close to the rim of thesidewall El-50448 tool starts by the start switch Successful to read the sensor information when the horn bleeps once Step 3 - Same method to read other information Follow the instuction above to read of the front-right, rear-right, rear-left wheels. Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete. For certain vehicles equipped with a Monitoring (TPM) system, a "Sensor Re-Learn Procedure" must be performed after rotations, Remote Control Door Lock Receiver Module replacement or Sensor replacement. This re-learn procedure can be performed by using special tool 50448
Trustpilot
1 month ago
2 months ago
