16.4ft Cor-Ten Steel Landscape Edging, 5.5" H Garden Edging Border

We liked this product. We needed it for an edging for one of our landscape areas. We wanted to back fill with pebble stone. Love the look of it. It did take 2 of us to put it in the ground. First person had the start & the other fed it out. It's best to measure your area as well. Ours is curvy as it goes along our landscape. We bought pea gravel to edge it. Looks great !

Too flimsy

I only give 4, because its so hard to unwind, but its great quality and the finish I like

As a disclaimer, I have bought the more expensive 14GA 40" hammer in place edging in the past in areas next to grass which I still recommend. I actually used this product to edge within a flower bed between dirt, stone, and mulch section. The final result turned out great at a substantial savings. It is easier to free form but overall harder to work with than the 14GA edging. I used a straight edge shovel to form a trough where I could place the edging and then backfilled (no hammering in place). It bends easily, but I was able to straighten by placing a flat surface on one side and using a large rubber mallet on the other side similar to pounding out a dented fender. I bought the 33' long roll and the first part of it rolled out nicely but as I got closer to the end it is wound so tight that the last 10' is wrinkly. The manufacturer should wrap the product around a cardboard core with a diameter sufficient to eliminate all or most of the wrinkle problem.

Not worth it! It’s too thing of a gauge, hence why it comes rolled up. But it’s not study at all. It bends very easy but if you happen to bend it the wrong way it end up with a ripple in the line. It won’t look smooth. I should have known this but I was looking for a less expensive option. 🤦🏻‍♀️

Beware - The pictures make it look easy. The gage should be heavier. Note: I bought pins to keep it were it needs to be in the trench. I made a special tool to capture the top edge. 2 blade cuts width in a 4x4, 2.5 inches deep, 5 inches long, used to set the border. Make sure to soak the trench, otherwise you will damage the the metal while setting it.

Nice

Had purchased product before with no problems. This time, the edging came completely different, with metal shiny part showing, completely unusable.

Nothing really wrong with product. It was rolled so tight, could not unroll without bending it every which way.

Haven't used it yet, but the product is what I expected and true to the photo and quality.

My partner bougth this. He said it's very good quality. Easy to install, medium soft and very good value for money.

Very thin metal, not easy to use as it needs to be unrolled and flattened out to enable you to work with it. Worth a try in my view but I don’t think I’ll be getting any more of it!

Because it’s rolled, it has a lot of ripples in it when putting it in