XLTTYWL Starlink Gen 3 Pipe Adapter, Starlink V3 Pole Adapter- 0.83-2.17’’ Premium Starlinks Pole Gen3 Mounting Kit for Star Link Standard Gen 3/V4 Kickstand Dishy

I must say, I was pleasantly surprised by the quality of this XLTTYWL Starlink Gen 3 Pipe Adapter - it's very well made and looks professional and more expensive than it costs.The installation was easier than I expected. The instructions were clear, and within minutes, my satellite was ready to go.Stability is crucial when it comes to mounting satellite equipment. The XLTTYWL adapter is made from robust aluminum alloy, and boasts an impressive weight capacity of up to 500 pounds! I feel confident that my Starlink setup is firmly anchored, no matter what Mother Nature throws at it.Overall, the XLTTYWL Starlink Gen 3 Pipe Adapter has exceeded my expectations in terms of quality, ease of installation, and stability. It not only serves its purpose but also looks great doing it.

This adapter allows to install Starlink Gen 3 on a pipe mount.Installation is quite easy and straightforward, all you have to do is to push the adapter into the indent at the back of the Starlink unit, and fasten the bolt on the pipe.The bolt on the pipe mount allows for different diameters pipes to be installed, the diameter ranges between 2 and 5.5cm. As for me I felt that the bolt is too close to the edge of the pipe, increasing the risk of the pipe sliding away.I also really liked the thoughtfulness of the design, specifically the slots for running through the cables.

This is a very good quality pipe adapter that allows the generation 3 star link internet kit satellite to stay properly on the roof where I have installed it.It has a good design that allows to place all the elements inside and also provides good protection from water allowing as well to have a precise position.The installation process is quite easy just requiring me to slide in the adapter into the pole and tighten the screws and since I have installed it, it provides the necessary support that I needed.

Far too shallow to be able to get a secure fixing to a pole. Not fit for purpose and I would definitely avoid using this adapter if you want to keep your starlink kit safe and secure. One bolt to hold the bracket on as well is another very poor part of the adapter. Avoid!!

Need to use with a larger pipe. I used it with 1"1/4 pipe and had to make wedges to hold the dish secure

This is a high-end adapter that is very much suited to its intended purpose and is also much better than the lesser plastic alternatives. It comes with an Alen key tool to mount it, as well as clear instructions. Highly recommended.

I do use this portable rather than on the vehicle itself using a heavy base and a 4' pole. I have experienced no flex in moderate winds and it performs exactly as described.There are a few different types of bolts included so you have a range of options for mounting.For what you get, it seems quite expensive but it is fit for purpose and I have no complaints.

Does it work? YesDoes it do a good job at holding a sale shaped 300 pound bit of kit in the air in the wind,,, noMine had tabs bent out too much (no spring in them and relaying on bending the body of starling) would not grip until I tweaked itAlso the pole accepting hole is way too shallow, dosnt list diameter of pole needed anywhere!! But it does have a good tolerance however hole is too shallow and wants to wind off when tightening the set screw that sits on last couple of mm of pole !Wouldn’t buy again but done the job with modifications to make it acceptable