Frepia Mini Split Ductless Line Set 1/4"-3/8" x50'

It was too late to return this item because I had already unrolled the whole 50 feet and I was in the middle of the project. The problem with this lineset was that it was a little thicker than usual and the 3/8 nut will not go in, I had to use a drill bit to make the nut hole bigger because of this defective lineset. I installed 3 minisplit with the item and it was a pain to make the nut go it. For some reason I could not make a perfect flare with them. I have experience doing flares and I could't make a perfect one with this lineset. I should have taken some pictures to show what I am talking about.

I ordered 3 of these for a 4-zone mini split installation and have been very happy with them during the installation. The "easy pull" insulation covering does help the piping slide through holes in the wall, etc without excessive snagging. I used two full runs for two zones and then cut the third line set to make the third and fourth zones. No flare nuts were included, but those are usually supplied with the minisplit system.

The outer shell is more rip resistant than older line set designs, and along with both lines being attached, allows for easier, damage free pulling.

Perfect size and function. Works for intended use

I used these to install three ductless mini splits and this was the first time I used these types of pipes. I don’t have much to compare them to but they worked really well.

The insulation is thinner than other brands. The end caps fell fall off easily. On one of my purchases, two were off before it was unwrapped.

needed 4 50Needed 4 roles clean ends for flaring!!

2 fittings failed over the course of a year, leaking all the freon out of my system. AC guys cost me $800 for 2 separate trips to replace fittings, vacuum the lines and fill with new freon. Do yourself a favor and pay for quality - you'll be better off in the end