LeMotech 12 Way Circuit Breaker Box IP66 PC/ABS Alloy Plastic Transparent Cover Power Distribution Box with Bus Bars,Din Rail and Padlock (12 Way）

The item was just as described. Would purchase again.

Too tight.

I love this product, I just unpack it and installed it, so far so good, it comes with everything you need for the installation.

Good design, enough space for wires and such.

The front (removable) part of the enclosure, not the swing out door, but rather the part the doer is attached to has an odd shape. The interface between the front and back is not a simple flat square shape. Instead it reaches back deep on the sides. This prevents it from being flush mounted nice and clean in a wall. You either end of with gaps on the side, or the panel sticks way further out than makes sense. Perhaps this was done for strength, but once it is all screwed together, the whole thing is a box. So, I just don’t see the reason for the odd sides. Top and bottom portion of interface is fine, it’s just the sides that are uneven. Other than that the circular cutouts, or knockouts, were imprinted in the plastic, but circle was not thinned out. That made it very hard to remove the circle for access ports. The knockouts are not getting knocked out at all. You’re better off just drilling it out with a step bit.

This mini power distribution box is IP66 waterproof rated . The housing is a light gray plastic with a hinged and a lockable breaker area lid that is lockable (combination lock included). It also includes breaker aluminum alloy DIN rail, two brass wring bus bars, two cable glands and a mounting hardware package. Breakers and wiring not included. The box's small footprint allows it to be mounted in most any wall location. I used this to mount three breakers without any difficulty. Am using this in my solar charging system.Would recommend this to anyone.

This is a lower quality box. It came missing two screws to hold on the cover. I'm searching for replacements. The rubber gasket to waterproof is very thin. The DIN rail is very thin metal with ends cut that are jagged. There are only 4 spacers included. So unless you use 8 breaker spaces, the front will be open. And you have to drill through the plastic back to mount the box. The neutral and ground buss bars are so close to the sides of the box they can block access to the retaining ring of a conduit terminal. I would look somewhere else if I had the time.

Breaker box worked decent. Issue with the knock-outs do not knock-out. You have to drill, cut etc.