VEVOR 3/4HP Electric Motor 1725 RPM, AC 115V/230V, 56 Frame, Air Compressor Motor Single Phase, 5/8" Keyed Shaft, CW/CCW Rotation for Agricultural Machinery and General Equipment

Good. Replaced a 50 yr old motor on a Craftsman table saw

This motor replaced a non-working one for a band saw that my husband uses. Very easy to install and worked well to cut wood the this try.

Looks and runs pretty high quality. Had the same problem with the knock outs as others and had to use a hole saw. Great deal for the price. It’s physically larger than other 3/4hp but was able to make it work by removing the fan and fan housing, not a problem for my application. Wiring instructions were from an older version w/o a circuit breaker but I figured it out.

Works like it should, was shocked how fast it got here, it was packed well, knock outs could be stamped a little better it was like trying to get the government to do something , getting them out of the junction box , worth the money

I bought it as a replacement motor for my Sears - Craftsman 10" Table Saw. The specs matched with regard to 1.5HP and 3450 RPM and another reviewer said it was a direct-bolt replacement. Having said that, the motor comes with 6 internal wires and a ground terminal all which need to be wired to your own 3-wire cord. It's up to you to decipher the chart as to whether you're going to run in 120v or 230v, as well as Clockwise or Counterclockwise rotation. So, you'll be staring at the chart for that a while and basically figuring out which 3 wires go to the hot wire of your own cord and which other three go to the neutral (for two sets of 4 wires nutted together total). The directions say it's pre-wired for 120v but, after studying, mine was clearly set for 230. It also hinted that it may be set for Counterclockwise rotation but mine was clockwise. Other than that, the motor is larger than my original and did bolt up fine however, the larger motor size pushed the shaft sideways out of alignment with the pully on the table saw. I simply flipped the pully the opposite direction on the motor to ride closer to the motor housing and got both pullies to line up. Minor note: Since the motor comes with a wire box and punch hole for your power cord, I wish it came with a cable clamp for the box.Looking forward to another 30 years of use out of my table saw.

I was a bit hesitant to buy this after seeing the reviews, but I have been pleased with how it’s been working for me. I used it to replace my old delta unisaw motor on my table saw now for about a year or two and it has worked very well. I haven not had a single problem with it at all.

I had to replace my old motor on my table saw and the cost for this motor is great for a penny pincher like me This bad boy has power and it’s very quiet for it’s size it bolted right on with no problems except that I had to have my brother in-law help me wire it up with a new plug other than that it’s smooth cutting from now on

Do not buy these motors. I got mine Sept 1st. Only 38 days and the motor won’t run because starter compacitor doesn’t work. I’ve tried several times reaching out to them. There site is no help. Stay away.

Las terminales NO SON DE COBRE, vienen con una aleación de alucobre, espero tengan la resistencia y durabilidad del cobre...