Sommerfeld's 3 Piece Glass Panel Door Set, 1/2-Inch Shank

This router bit set gives you clean and consistent cuts with no tear out on the rail ends. The bit set up is easily achieved with the first bit. This set is worth the money with the results I experienced.

I used this product line exclusively for building custom cabinets, for my remodeling jobs. I'm always very happy with the outcome!

Love these bits best investment ever comes with rubber gromet for router diffently order other bits

I am somewhat disappointed in this set. I followed the instructions as shown in the video. The video is excellent. However the top rails didn't line up with the side rails. The rails are a 16th inch off and will require sanding to make them flush with each other. When I opened the box there was a small note on a piece of paper that stated if you own a Porter Cable router, you will need to cut a 1/2 inch dowel rod 7/8 inch long and then insert the rubber grommet on top of it. This is so all the bits are at the same height. Also you need to make sure you make several passes depending on the hardness of the wood your using. Not two passes as the video shows. The bits aren't that sharp.

The router bit with two cutters came with the top cutter loose. I aligned the cutters and tightened the nut. I started to use it and it was dull. After sharpening the cutters and taking four passes to make the cuts instead of the two recommended by the manufacturer, having two pieces of African Mahogany chewed up, and a lot of my time wasted, I got reasonably good results. I am an experienced wood worker. I will never buy something made by Sommerfield's again.