Magpul 308 Mag Assist

This work as advertised. were tight enough to install with little effort, with enough friction so they don't slide off. Less than a minute per M1A Mag.Fast shipping, Would buy from again.

Fit perfect for 20 rd m14 mags. Hard to get on, but you know it's not sliding off.

A bit tight on some polymer mags because they're thicker than steel, but they work good and worth it.

I bought the AR-10 version with the intention of adding to my FAL magazines. It went on tight, however it appears to work well on this application. I’ll update of a failure occurs.

I purchased these for my Springfield Armory SOCOM16. Installation is quick and easy for the 20 round Check Mate manufactured M1A/M14 magazines. Functioned as advertised.NOTE: These do not work correctly with 10 round magazines as the magazine will not seat in the magwell when the magpul is installed. I tried to use it with the magpul partly installed but it ended up sliding off when trying to pull the magazine from my pouch or from the magwell.

Works perfectly on my m1a

These were to tight to squeeze ove a mag for a Savage Scout rifle. I will try to loosen them up with a heat gun and see if I can get them to slide over the end.

Fits great on m1a/m14 box mags. It also adds a nice softer edge on the bottom of steel mags which can be rough. *I will say this is not great on 10 round mags due to clearance it become very hard to push the mag release and rock the mag out i had to two hand it while laying the rifle down.