VEVOR Electric Hoist, 2200 lbs 120V Electric Winch with 328 ft Wireless & 14 ft Wired Remote Control, 40 ft Single Cable Lifting Height, Single/Double Slings, Lift Hoist for Garage Warehouse Factory

Basically I've used this for other than intended. Basically in combination with a wheel chair ramp.In order to safely move a person in a wheelchair up and down a 10 foot ramp at a slightly steeper that intended angle I ground mounted this to a porch surface. Allowing the slow and steady movement of the chair up or down the ramp with ease.More than just a hoist.

Installed this in my garage, ran mobile track in the ceiling to lift heavy items,too old and too weak to lift them,works like a dream,.wish I had it years ago, would definitely recommend it

This hoist when installed as described is a game changer in my opinion. This allows me an older individual to lift heavy things up to higher areas of my garage. If you happen to be anal about clutter this device along with the track, rollers and hanging devices are a must have!

It's not bad.An item was missing but the seller was easy to contact, I later got the missing part.

Work great, quiet and smooth. Has a lot of torque so it does need to be installed properly. About 2 months of use so far and I would recommend to others

Very powerful. I used this in construction of my attic lift. The best part about this lift is the dual controllers. One is portable and the other is hard wired. Perfect for my application.

I bought one of these winches a few years ago. Works well so far, I use it to store my 5th wheel hitch up in the overhead of my shop. It only gets used when removing or reinstalling my 5th wheel. It is a little noisy but that is to be expected on a winch in this price range. So I bought a second winch to put on a rail in my shop. Surprisingly enough it is somewhat quieter than the first one and seems to function OK for what little I have used it. My problem is with the poor final assembly of the winch.Photo 1 - One of the welded on nuts used to install the hanger brackets on the winch was welded in at an angle.Photo 2 - The spring, washers and safety stop disc (Red Arrows) were assembled on the wrong side of the swedge. In this configuration the traveling block cannot be used. I removed the swedge, positioned the parts on the cable where they should have been and place a clamp where the swedge was and put on the traveling block.Photo 3 - The washer was the wrong size to keep it from being dragged into the traveling block. Fortunately I noticed the problem before it was under load or it would have damaged the spring and other parts. (Red Arrows)Photo 4 - I cut the end off the cable, removed the lower washer and replaced it with a fender washer (3/16" X 1 1/4") so the hoist stop would not bind with the traveling block and allow it to operate as intended. Then I put 1/8" cable clamps were the swedges had been.Evidently they don't do much for final inspection on these winches before shipping them. These were problems that should not have happened and if they did, they should have caught them prior to shipment. If I had used it like it was delivered the safety stop would not have worked as intended and likely damaged the winch or winch parts.

works great. if needing a rail to slide the hoist on, be sure to get the correct clamps to install the rail correctly and easily. This hoist works fantastic and is quick and quiet.