Thermal GrizzlyTG Putty Advance - 30 Gram - Electrically Non-Conductive Thermal Putty for GPU Modding and Thermal Pad Replacement

Does what I need it to do. Lowered temps significantly. Easy to apply ( I suggest using gloves for small components ). Great value for the amount you receive. Would buy again in the future

Don’t know how much better this is or isn’t compared to thermal pads I had, could just as easily been the fact that the ones on this old GPU were just too dry. But this worked well with updating an old GPU with a combination of Thermal Paste, Pads and Putty. Bit expensive but hopefully this’ll last longer and give some much needed vitality to some older equipment.

it does feel of good quality but tbh if i service another laptop and need stuff for ram i will have to go with thermal pads as this stuff confuses me its not easy to apply

I have some real misgivings about the reported thermal conductivity. Seems like a lot of hype and packaging. But so far it's keeping the inductors in my gaming laptop cool enough.

This stuff is phenomenal. Strong performance and makes contact a non issue. I have a bykski block that is nice but it always requires me to reopen the darn thing a hundred times before everything is right. With the putty it worked without hassle, card can be repasted in 5 minutes. Probably the first time I’ve ever got it closed up without some kind of imperfection, too.Regarding mess, it is harder to clean, but not so much that you need to seriously worry about it if you aren’t going overboard. The putty is also reusable if you handle it right.Only real issue with this product is just like other TG products it is expensive compared to other putties, but it is actually pretty competitive.

This stuff seems incredible. In combination with some PTM7950, my Acer Nitro 5 dropped from 92C to barely cracking 60C while gaming. Absolutely phenomenal difference in thermals.

I used this to replace my thermal pads on my rtx 3080 since I was already repasting the card. Temps are lower and Igor’s lab results aligned with my results. The temps were far better than pads. I don’t plan on removing this stuff within the life of my GPU. I can’t recommend it enough. Be sure to check if you put enough and the putty is making contact with your heat sink on your gpu. (I highly suggest using the middle tier but i will test the pro on my next gpu).

Rarely leave any review for product as all have been said on most. But this thing knocked the temp off of my 4090 hotpot. Tested with CP RT overdrive, Furmark. Was getting 85C on full load @ 430W. now it is constant @ 73