8 Large Square Rubber Feet Foot Bumpers w/Stainless Screws - .590 H X 1.500 W - Made in USA - Heavy Duty, Non Marking for Furniture, Tables, Chairs, Desks, Benches, Sofas, Chests, & Other Items.

Not much to say about rubber feet, these do the job. The rubber is a little harder than I expected but it's sticky enough so the box I mounted them to doesn't slid around. Since they are square, they include little tenons to prevent them rotating after installation. The tenons require you to drill two shallow holes, in addition to the central screw hole, to accommodate them. The drawing on the product page shows the dimensions, I verified that they are correct. There's a removeable metal insert that bears the squeeze from the mounting screw, so the rubber doesn't distort. Overall quality seems high. If you don't want to deal with the tenons you could shave them off, otherwise the feet will fail to sit flush - won't look good. But then you risk the feet rotating out of alignment. Best to use round feet if this is an issue.

Well manufactured. Very high quality product. I was surprised by the quality considering the very affordable price. And it is made in the USA.

Every other screw broke in two. Working with 10 gage square tubing. Drilled a pilot hole .030 smaller than screw. Then I pushed in a self tapping metal screw, none of which broke. After backing it out, I pushed in the provided screw with my DeWalt drill motor clutch set on 2. Every other provided screw broke in two. I was able to back them out using a pair of Vise Grips. Sometimes the next screw went all the way in and snugged up, sometimes it broke off. Bought more screws which are stainless, because we live near the coast and this is Patio Furniture I'm working on. They did a little better, but not without some breaking. If the recessed center of the rubber pad had been larger I would have used 12x3/4 self tapping screws for the job and been done. I hope this review is helpful.

I use these as a spacer between my garage workbench and the wall behind it and they worked great.

The feet/bumpers are well made of a rubber type material. They were just what I needed. I didn't need feet for my cabinets, just something to lift them off the floor so the doors wouldn't drag. They fit the bill perfectly. I wasn't sure if something like these existed. They do! Just search "bumpers".

These worked great for my sectional on a hard floor. I replaced all of the original feet and now my sofa doesn't slide around. Only issue was that the screws are only 3/4". You lose 1/4" from the spacer in the foot only leaving 1/2" which was not enough length. 1" screws worked great.

Very outstanding product, except for one thing the screws need to be at least a half inch longer to be able To do the job that they are supposed to do, less than 1/8 into the wood is very poor decision on your side I would have to say. Sincerely.

I recently installed bass shakers to my homemade Sim Racing rig. (Made from 2x6, 2x4, and 3/4" MDF) The vibrations transfer through the floor quite a bit, and bothered my wife. I found these rubber feet, and ordered them. I now have one in each corner, and four in the middle, evenly spaced. It works a charm to insulate the vibrations, but also the rig feels more firm against the hardwood floor, as it doesn't slide anymore when I shift my weight. Super easy to install. One screw in the center of each. And, no problem handling the weight. (With myself seated, the entire rig is easily 220 lbs+)