AP Automotive 16mm (5/8 Inch) Corrugated Flexible Pond Pipe Repair Connectors Hose Joiners

Het is een simpele 3d print niet sterk jammer

Lasted just long enough to do the job I needed to join two pipes then fractured between two of the grooves under a very slight pull to remove it- from how the surfaces appear, I suspect this is 3D printed (concentric circular failure mode at the split). If you need a strong, permanent connection, go brass/stainless), I wouldn’t trust this product beyond eyes on. But cheap!

Absolute rubbish. It’s 3d printed, and not just that it’s printed but it’s been printed such that the layers run across it. That means it’s really weak in the direction needed for bending strength. Not only this but they have made it really thick leaving only about 6mm bore diameter down the middle meaning it will be really restrictive. I don’t leave many reviews unless I’ve literally been ripped off. 3d printing is good for some stuff (I should know I’ve had loads of 3d printers) but using it on something like this and printing it in this way is criminal!

Really poor quality 3D printed part, won’t last especially outdoors, too light to be a solid print. I could have printed this myself for a few pence and done a better job. Looks nothing like the image either, about half the length as shown.

Absolutely terrible. Snapped while on my car ans nearly caused major issues