Tubes of Repair PVC Glue for Inflatable Boat

Used this product to seal two punctures on my son inflatable kayak. Process was easy and the patches and adhesive of high quality. Let it cure for 24 hours. Patches held. Great product!

A mouse nibbled a small hole in my SPB over the winter! This repair kit did the trick. Holds air now and with 2 glue tubes, the patch kit might last until needed again.

Small enough and I ordered it to have it on my inflatable boat just incase if needed as a safety measure.

Easy to use and sealed up the hole in my SUP perfectly!!! Saved my summer!

This item is OK. Nice orange container. A few different PVC patches and 2 tubes of MEK glue with instructions. Kind of pricey for what it is.

I accidentally stabbed a hole into my inflatable paddle board when adjusting my fins ( silly mistake I know) but this patched it right up! I followed the directions carefully ( I’ve seen people say this doesn’t work, follow the directions and it will) and it patched it perfectly. Within the next few days I took my paddle board out and I had a very successful and enjoyable 4 hour trip on the water; the patch continued and continues to hold up. I will say I put some gorilla waterproof sealing tape over the patch as an extra precaution but I think I would be okay without it. Definitely recommend this if you need to seal some type of inflatable.

First time I tried to patch my board all I did was put a layer of glue with a patch on top and it didn't hold. After cleaning up all of the glue from my 1st try, I left the area rough like it had been sanded. I put the patch on the second time according to the directions in the kit and left a 40lb weight on top of the repair for two days. After a few more days to cure I left it out in the sun for a couple of hours and then filled to a full 15psi and haven't had any problems since.

I was able to fix my paddle board while I was out using it! I punctured it while I was out and had this kit in my backpack. Easy fix!

J'ai acheté cette colle pour reparer mon zodiac afin de ne plus acheter de la bi composant. Efficace, resistante, prise rapide.

Rien a dire

This kit worked perfectly on two holes that were both roughly 12mm in diameter in my inflatable boat. Cleaning the area to be glued with acetone (not supplied) is 100% essential, I also cleaned the patches supplied with the kit beforehand too. Apply a covering of the glue to both the area around the hole and the supplied patch, then wait 5 minutes before applying a second coating to each once more. 5 minutes after the second coat I then applied the patch over the hole, rubbing the two together with a blunt wooden straight edge. I then left the glue to cure for 48hrs before inflating the RIB (HD Quicksilver 3.5m) and it has held beautiful under load on rough seas. I recommend this product 👌 but acetone must be used pre-gluing in my opinion. I hope this helps 🙏

The butyl rubber that makes most kayaks and SUP's is not thin nor cheap so why buy a cheap thin rubber kit? I bought a used 2 place kayak, it wasn't cheap and it's designed for ocean use as well so the rubber is much thicker and can take a few runs across sharp rocks before it will puncture. So...when it came time to order a patch kit, I wasn't about to go cheap nor should you. The rubber patches are quite thick and the glue is also not a tire patch glue, it's designed for this specific application and I got 2 tubes within this tube. Not sure why but there is not carabiner hole or lanyard attached nor is there a place to do so, that was the only odd part about this. Overall the storage container isn't water tight, more water resistant so I've placed this is my waterbag when I go out kayaking. I'm happy with this decision and purchase, the right tool for the right need.

I used it for my owerground pool. I can you use the glue direct to the pool licking aria. I tryed many glues but this working fine.