Kai Corporation Seki Son Roku Tumekiri Type 101

使い始めだから切れ味は良いです！古い奴よりサクッサクッ切れる音　分厚いところはパチっと行く爪切りの隙間は以前のと同じで標準。不満あるとすれば切ったあとの爪切りの戻りがスムーズじゃない所かな。戻りに抵抗あって次の所切ろうとしても隙間が狭くて入らない。使っていく内に馴染むかもしれないけど最初の使い心地としてはそんな感じちゃんと切れるし爪も飛びにくいから、値段に対してこの出来なら満足！

切れ味が良く、爪がサクサク切れます。ただし、ヤスリが小さく使いづらいので⭐️ひとつマイナスです。

切れ味が良く、軽い力でスムーズに切れます。持ちやすくて使いやすく、細かい部分もきれいに整えられました。作りもしっかりしていて満足です。

切れ味はまあまあ。爪をハサミ難い（慣れが必要？）詰め切り後の磨くのは側面の狭い幅の部分だけ。あまり100均爪切りとの違いを感じませんでした。

100均からのステップアップです！重量感からくる切れ味、満足です。

軽い力加減でよく切れます！

切れ味最高。ヤスリもあればなおよし

100均のものと比べると別次元なくらいに気持ち良く切れます。切り口も綺麗でお勧めします。

These blades are sharp, and cuts clean, only require a mild sanding with the included nail file on the side. The cut nails fall nicely in the catchment area for easy removal.These might be a bit unwieldly for those with tiny fingers though. (W26 x L90 x 18 mm)

Simple to use, very sharp nail clippers with a very smooth action unlike other clippers that fall apart. These are well constructed and deliver.

After doing a bit of research, I couldn't decide between this one, and another above average Japanese made nail clipper.The reviews initially of certain Japanese made nail clippers seemed to suggest they're quite a bit better. Though it's hard to say, time will tell. However, initial impressions after a few uses, is that the tolerances for a good cut may be slightly better than all of my other nail clippers. They do seem to cut more smoothly, resulting in a less sharp feeling of the nail - needing less filing afterwards to remove any sharper edges.I even keep my other nail clippers sharpened with a little maintenance, but none of them cut as nicely, so maybe there is something to it.If you figure your typical set of clippers costs ~ $10 at a box store, or you need to pay 3X as much for a pair that does a better job, you probably would save a bit of time in the long run not having to spend as much time filing your nails.Both pairs of Japanese clippers I bought do share one aspect I've found more impression - the build quality. The tolerances for how everything comes together, the mechanism, the way the pressure is applied, it's obvious they are built better - both seem to be engineered slightly more, using thicker metal stock, or designed with gussets to improve the rigidity, and resulting in a more "solid" feel.

Works really well, best nail cutter I have experienced so far.It is expensive but will be worth the money if it can last for for at least a decade (last I used was from scoll and it good but lasted only for 4-5 years.

The finish