Dremel 199 Rotary Tool Accessory Carving Bit- Perfect for Wood, Plastic, and Soft Metals

I used this to widen the scratches on my boat for repair. Worked like a charm!

ok

I recently built a shelf using about 70 pocket holes and 70 pocket plugs. This time around the wood was Red Oak and so were the plugs. I did not cut the Red Oak plugs down ahead of time which would have made them more flush, but instead I cut the Dremel cutting guide in the "Dremel 565 Multi-Purpose Cut Kit" so I could approach the plugs and used the 194 bit raised to about 1/32 of an inch from the surface. As long as the cutting guide was held flush to the wood it made mince meat out of the plug. To avoid creating a lot of smoke the bit is designed to cut in one direction (although if you force it you can cut in the other direction and create a lot of smoke in the process).Once I ground (routed) one plug down, I was able to use the multi-tool sander to flush sand the remaining amount and then wood filler as needed.I tried using a flush trim saw, but it was a lot work and if you don't watch it the saw can actually cut into the adjacent wood. This router/grinder worked much better and was consistent so long as you kept the cutting guide flush to the surface. For routing on narrow wood I clamped more wood to both sides and made if flush with piece of wood with the pocket plug.This router bit in this application saved me lots of time. Now that I modified my drywall cutting guide, it was time to replace it with a new one i.e. this purchase.

Works well on soft materials, like plastic and wood. It doesn’t cut too aggressively, which makes it easier to control. I’m using it to sculpts small wood turnings.

In past 3 years and during the winter that product was got in time and I used this product for carve the metal,plastic,and wood that I need thank you.

I used this for this first time today. I was impressed of how this cuts through plastic so smoothly. I have to make my columns at work a little bit bigger inside a enclosure . This saved so many minutes the way this tool cuts and my battery life.

This is almost a no brainer, but just in case...Dremel makes a number of sizes and shapes and so do other makers. The Dremel products are the ones to get as their shapes are exact, the cutting edges are precise and the steel is top quality and tempered to last a long time when used properly. These are made for the careful removal of stock from soft materials like wood and plastic...with the speed set fairly low to avoid burning or annealing the steel of the bit. Hard woods like Ebony, Rosewood etc. might be too hard. Keep a small stiff brass brush close by for clean up if you're working on plastic as they will often melt to the burr. They're not cheap, but they do last a really long time. I've even sharpened mine with a very fine needle file.

I bought these for my wife and she used them for crafting. They work exactly as advertised.