MAGNI-View 3X Mask Magnifying Lens Great for Scuba Divers and Water Sports

I used this on a dive trip recently and it actually works. It's cheaper than buying a prescription mask. Easy to install if you follow the instructions.

I was hoping to add this to a new mask. Followed the directions to a 'T'. You only have one shot to get it right. But very little glue came out of the packet, only enough to put a smudge on the lens. I called an "abort" and cleaned off the mask and lens before permanent damage was done to either. I will seek another adhesive or more from the manufacturer.

I installed the lens very carefully, (be sure flat side of lens is the side the glue goes on and do not use more than a drop or two of glue), in the lower left side of my mask. I followed the instructions and cleaned the excess glue away with a q-tip and soap and water before the final cure of the glue. I used the mask on two dives this past weekend and it worked quite well. The lens is very clear and does not bother my general area of vision but allows me to look through the lens when I need to view my computer and gauges. This is a good alternative when you do not need a full prescription lens mask but just need a little extra help with a clear view of your computer, etc.

I applied the lens carefully and it has been on for 2 years now without a problem. I can read my dive computer and the lens does not interfere with my vision. Hooray!!!!

I've tried other brands of corrective lenses and they all fall off after a few months of use. These work great, the optics are very clear and they are simple to install. Little pricy but compared to corrective optics from the major scuba mask manufactures, they are a steal. Wish they'd just sell them as a two lens bundle at a slightly lower price. I can't see any good reason to only have one eye corrected for reading gauges and your bottom timer.Note: You'll want to place these in the correct location on the first attempt. Once they are installed and cured, you can't remove them.

Amazing. Solid, clear adhesion and great magnification and clarity at about 18" - 24" away from mask - just where you would hold your computer. Thanks!

Needed product for up close magnification. Once adhered to swim mask couldn’t see through it.

This thing works a charm. Just the thing for underwater photogs who cant see up close anymore. Just PAY ATTENTION to the instructions and do exactly what it says. Be very careful when getting the glue out and on the mask not to get bubbles in the glue when you squeeze it out of the package. if you do, get a straightpin and work the bubbles out BEFORE tryiing to put down the lens. Stay OUT of the sunlight while doing all this, UV cures the glue quickly (a minute or so). Then just put down the lens carefully and press very gently. It will pull down as the glue sets. Once set, only heat will release it